information concerning folding requirements that would you expect to find in the job documentation or production control system information interpretation to ensure smooth workflow throughout the factory factors that must be considered when planning a folding sample OHS factors that must be considered when setting up and/or operating machine transport systems areas of the reel stand that should be monitored to ensure trouble-free operation area of the web control system that should be adjusted to maintain correct web tension area of the web control system that should be adjusted to maintain correct positioning of the web OHS factors that must be considered when setting folder transportation and delivery systems areas of the sheet-fed transportation system that should be monitored to ensure trouble-free operation parts of the sheet pick-up system that should be adjusted to ensure accurate and continuous sheet handling areas of the delivery system that should be observed to maintain neat delivery of finished work areas of the delivery system that should be observed to prevent damage to the finished product checks to be made when substrate is removed from the machine ways in which the folded sheets can be secured for dispatch OHS factors that must be considered when setting up and/or adjusting the folding unit largest/smallest size sheet that can be processed on this machine adapting the machine to facilitate smaller/larger stock factors that determines the accuracy of sheets entering folding rollers causes scratching/scuffing of substrate during transportation factors that determines the speed of the machine adjustments to be made if the sheet is not reaching the fold unit adjustment to be made if the sheet is turned on the transportation unit problems that can be expected if the machine is running too fast problems that can be expected if the machine rollers are set too loose problems that can be expected if there is too much roller pressure problems that can be expected if the delivery system is not set correctly factors that determines the correct roller pressure for a given job roller pressures checks for correctness adjustment to be made if the sheet is out-of-square reasons for the sheet being out-of-square adjustment to be made to ensure that the sheets are not smudging/"scuffing" adjustments to be made if the sheet will not leave the folding unit OHS factors that must be considered when adjusting machine units steps that are taken to ensure correct alignment of in-line processes/units checks to be made when operating the electronic gate fold unit use of a gate fold unit use of a gluing unit on a job adhesive that is used in the gluing unit adjustments made to the length of the glue line causes of out-of-square folding and explain how each may be corrected segments of quality assurance that would be inspected at the completion of the sample run communication action that should be instigated if job is out-of-square communication action that should be instigated if ink is too wet for production communication action that should be instigated if job does not coincide with sample areas of the machine that should be adjusted if the sheet is creasing areas of the machine that should be adjusted if the sheet is caught in the fold plate areas of the machine that should be adjusted if the sheet is not entering the machine items that must be checked against the client's sample machine manuals, safety and other documentation that are relevant to this task and where they are kept and information that is included in these documents
|