reel handling system OHS requirements when maintaining and cleaning the reel handling system common causes of failure or breakdown precautions that must be observed when working with compressed air damage caused to electronic sensors during cleaning checks that were performed on this area of the machine particular chemical used for cleaning purposes sheet or object handling systems OHS requirements when maintaining and cleaning the sheet or object handling system common causes of failure or breakdown problems with inefficient cleaning parts of this area of the machine that require cleaning effect of excessive lubricant in this area of the machine need for regular maintenance of this area of the machine. printing units OHS requirements when maintaining and cleaning the printing units common causes of failure or breakdown problem that arises due to continual inefficient wash-up of roller surfaces necessity to clean the bearers on all cylinders in the printing unit problems that could result from cylinder bodies not being cleaned correctly safety devices that were checked in the printing unit action if a safety device is found to be inoperative checks that must be carried out when replacing rollers in the inking system ancillary units OHS requirements when maintaining and cleaning ancillary units common causes of failure or breakdown checks that were performed on ancillary units precautions that should be observed when cleaning ancillary units cutting units OHS requirements when maintaining and cleaning the cutting units common causes of failure or breakdown checks that are carried out on cutting devices and knives storing of cutting knives after being replaced problems that would arise if the machine bed was not maintained problems that would arise if blades or knives were not maintained folding/collating units OHS requirements when maintaining and cleaning the folding/ collating units common causes of failure or breakdown components that were checked with this equipment problems with inefficient cleaning of the folding/collating unit parts of this machine that require cleaning type of lubricant used on this equipment and why fastening units OHS requirements when maintaining and cleaning the fastening units common causes of failure or breakdown chemicals that were used when cleaning this equipment disposal of used chemicals frequency this equipment should be cleaned problems that could be caused by inefficient cleaning parts of the equipment that should be cleaned the result of excessive lubricant in this part of the machine machine manuals, safety and other documentation that are relevant to this task and where are they kept and information that is included in these documents
|