List the assessment methods to be used and the context and resources required for assessment. Copy and paste the relevant sections from the evidence guide below and then re-write these in plain English.
Elements describe the essential outcomes. | Performance criteria describe the performance needed to demonstrate achievement of the element. |
1. | Inspect automatic flight control systems and components | 1.1 | Isolation tags are checked and aircraft configured for safe system inspection and operation in accordance with the applicable maintenance manual |
| | 1.2 | Automatic flight control system components are visually or physically checked for external signs of defects in accordance with applicable maintenance manual while observing all relevant work health and safety (WHS) requirements |
| | 1.3 | Defects are correctly identified and recorded in accordance with standard enterprise procedures |
Evidence required to demonstrate competency in this unit must be relevant to and satisfy all of the requirements of the elements and performance criteria under the specified conditions of assessment, and must include:
applying relevant WHS practices
using approved maintenance documentation and aircraft publications relating to the automatic flight control system being maintained
recognition of system and component defects/external damage, correct installation, connection of plugs, terminations, and attaching hardware (including cabling/harnesses) and security in automatic fight control system and components.
It is essential that inspection procedures, cleanliness requirements and safety precautions applicable to the electrical system being maintained are fully observed, understood and complied with. Ability to interpret inspection procedures and specifications (allowable limits) and apply them in practice (including the timely involvement of supervisors or other trades) is critical.
Evidence of transferability of skills and knowledge related to inspection is essential. This is to be demonstrated through application across a range of aircraft automatic flight control systems and components listed in the Assessment Conditions.
Evidence required to demonstrate competency in this unit must be relevant to and satisfy all of the requirements of the elements and performance criteria and include knowledge of:
component attachment methods
the basic layout (block diagram level), and operation of the system, including the interface with:
flight management systems
navigation systems
flight control actuators
engine management systems
relevant WHS practices
maintenance requirements
relevant maintenance manuals
relevant regulatory requirements and standard procedures.
Competency should be assessed in the workplace or simulated workplace using tools and equipment specified in the maintenance manuals. It is also expected that applicable general and special purpose tools, and test and ground support equipment would be used where appropriate. The work plan should take account of applicable safety and quality requirements in accordance with the industry and regulatory standards.
The following conditions of assessment represent the requirements of the Regulators (ADF and CASA) and maintenance stakeholders and must be rigorously observed.
A person cannot be assessed as competent until it can be demonstrated to the satisfaction of the workplace assessor that the relevant elements and performance criteria of the unit of competency are being achieved under routine supervision on at least one (1) item from each of the following groups:
automatic pilot
flight director
automatic trim
yaw damper
automatic throttle and automatic landing (may be omitted where it is not applicable to the enterprise).
This shall be established via the records in the Log of Industrial Experience and Achievement or, where appropriate, an equivalent Industry Evidence Guide (for details refer to the Companion Volume Assessment Guidelines).
Assessors must satisfy the requirements of the National Vocational Education and Training Regulator (Australian Skills Quality Authority, or its successors).
Where the unit is to be used for CASA licensing purposes the Assessor must also meet the criteria specified in the CASR Part 147 Manual of Standards.