This unit of competency defines the skills and knowledge required to carry out submerged arc welding (SAW) where the welds are more likely to be associated with heavy rather than with light fabrication.

Weld quality would typically conform to AS 1554 General Purpose or equivalent.

Where the interpretation of technical drawings is required unit MEM09002 Interpret technical drawing should also be selected.

Where the selection and use of tools is required unit MEM18001 Use hand tools and unit MEM18002 Use power tools/hand held operations, should also be selected as appropriate.

No licensing, legislative or certification requirements apply to this unit at the time of publication.

Band: A

Unit Weight: 4

You may want to include more information here about the target group and the purpose of the assessments (eg formative, summative, recognition)

List each assessment task's title, type (eg project, observation/demonstration, essay, assingnment, checklist) and due date here

Assessment task 1: [title]      Due date:

(add new lines for each of the assessment tasks)

Copy and paste from the following data to produce each assessment task. Write these in plain English and spell out how, when and where the task is to be carried out, under what conditions, and what resources are needed. Include guidelines about how well the candidate has to perform a task for it to be judged satisfactory.

This field allows for different work environments and conditions that may affect performance. Essential operating conditions that may be present (depending on the work situation, needs of the candidate, accessibility of the item, and local industry and regional contexts) are included.
Welds include the following:	fillet and butt in flat and horizontal positions
Materials include one (1) or more of the following:	carbon and stainless steel
Preparation includes one (1) or more of the following:	pre-heating setting up of jigs, fixtures and clamps joint preparation e.g. bevelling
Distortion prevention measures include one (1) or more of the following:	pre-heating setting up of jigs fixtures and clamps
Rectify includes the use of one (1) or more of the following:	oxy acetylene air arc equipment grinding devices
Defects include one (1) or more of the following:	porosity slag inclusions discontinuities lack of penetration undercut

Copy and paste from the following performance criteria to create an observation checklist for each task. When you have finished writing your assessment tool every one of these must have been addressed, preferably several times in a variety of contexts. To ensure this occurs download the assessment matrix for the unit; enter each assessment task as a column header and place check marks against each performance criteria that task addresses.

Observation Checklist

Tasks to be observed according to workplace/college/TAFE policy and procedures, relevant legislation and Codes of Practice	Yes	No	Comments/feedback
Follow standard operating procedures (SOPs)
Prepare materials to achieve the required weld requirements
Identify and select welding machine settings and consumables from job requirements, welding procedures and specifications and/or technical drawings
Apply appropriate distortion prevention measures
Deposit pad, butt and fillet welds in flat, and fillet welds in horizontal position, to specification
Inspect weld joints visually for conformance to specifications

Assessment Cover Sheet

MEM05023 - Weld using submerged arc welding process

Assessment task 1: [title]

Student name:

Student ID:

I declare that the assessment tasks submitted for this unit are my own work.

Student signature:

Result: Competent Not yet competent

Feedback to student

 

 

 

 

 

 

 

 

Assessor name:

Signature:

Date:

Assessment Record Sheet

MEM05023 - Weld using submerged arc welding process

Student name:

Student ID:

Assessment task 1: [title] Result: Competent Not yet competent

(add lines for each task)

Feedback to student:

 

 

 

 

 

 

 

 

Overall assessment result: Competent Not yet competent

Assessor name:

Signature:

Date:

Student signature:

Date: