This unit of competency defines the skills and knowledge required to assess the operation of compression ignition systems.

It covers the testing and repair of ignition systems used in large compression engines, including direct injection and common rail systems and repair and replacement of components.

Where interpretation of technical drawings is required unit MEM09002 Interpret technical drawing should also be selected.

Where the selection and use of power tools/hand held operations is required unit MEM18002 Use power tools/hand held operations should also be selected.

If the operation of plant and equipment is required, it must only be performed within the person’s licensing limits or as determined by relevant regulations.

No licensing, legislative or certification requirements apply to this unit at the time of publication.

Band: A

Unit Weight: 4

You may want to include more information here about the target group and the purpose of the assessments (eg formative, summative, recognition)

List each assessment task's title, type (eg project, observation/demonstration, essay, assingnment, checklist) and due date here

Assessment task 1: [title]      Due date:

(add new lines for each of the assessment tasks)

Copy and paste from the following data to produce each assessment task. Write these in plain English and spell out how, when and where the task is to be carried out, under what conditions, and what resources are needed. Include guidelines about how well the candidate has to perform a task for it to be judged satisfactory.

This field allows for different work environments and conditions that may affect performance. Essential operating conditions that may be present (depending on the work situation, needs of the candidate, accessibility of the item, and local industry and regional contexts) are included.
Fuel system components include the following:	tank filters sensors, including: engine position coolant temperature engine mass airflow (MAF) inlet air temperature engine fuel pressure boost pressure fuel delivery fuel rail pressure common rail electronic and hydraulic electronic injectors solenoid and piezoelectric valves pumps engine control unit (ECU) and associated components
Final adjustment includes the setting ofone (1) or more of the following:	low/high speed no load/full load speed droop sensitivity stability promptness

Copy and paste from the following performance criteria to create an observation checklist for each task. When you have finished writing your assessment tool every one of these must have been addressed, preferably several times in a variety of contexts. To ensure this occurs download the assessment matrix for the unit; enter each assessment task as a column header and place check marks against each performance criteria that task addresses.

Observation Checklist

Tasks to be observed according to workplace/college/TAFE policy and procedures, relevant legislation and Codes of Practice	Yes	No	Comments/feedback
Follow standard operating procedures (SOPs)
Apply knowledge of fuel injection principles and component part functions/operation to assess fuel system operation
Identify components to be repaired or replaced

Assessment Cover Sheet

MEM27002 - Test and repair compression ignition systems

Assessment task 1: [title]

Student name:

Student ID:

I declare that the assessment tasks submitted for this unit are my own work.

Student signature:

Result: Competent Not yet competent

Feedback to student

 

 

 

 

 

 

 

 

Assessor name:

Signature:

Date:

Assessment Record Sheet

MEM27002 - Test and repair compression ignition systems

Student name:

Student ID:

Assessment task 1: [title] Result: Competent Not yet competent

(add lines for each task)

Feedback to student:

 

 

 

 

 

 

 

 

Overall assessment result: Competent Not yet competent

Assessor name:

Signature:

Date:

Student signature:

Date: