This unit describes the skills and knowledge required to install synthetic synthetic turf and needle- punch floor coverings to indoor and outdoor sporting facilities and outdoor spaces, including the preparation, cutting, laying out, joining, fixing and finishing of the synthetic textile floor covering material.

This unit applies to flooring technicians installing coverings in accordance with pre-determined work orders.

Licensing, legislative or certification requirements may apply to this unit and relevant state/territory and local government agencies should be consulted to determine any necessary certification or licensing for undertaking flooring work. Industry standards and codes of practice within Australia must also be applied. Access to construction sites requires certification of general induction training specified by the National Code of Practice for Induction for Construction Work (ASCC 2007).

You may want to include more information here about the target group and the purpose of the assessments (eg formative, summative, recognition)

List each assessment task's title, type (eg project, observation/demonstration, essay, assingnment, checklist) and due date here

Assessment task 1: [title]      Due date:

(add new lines for each of the assessment tasks)

Copy and paste from the following data to produce each assessment task. Write these in plain English and spell out how, when and where the task is to be carried out, under what conditions, and what resources are needed. Include guidelines about how well the candidate has to perform a task for it to be judged satisfactory.

Copy and paste from the following performance criteria to create an observation checklist for each task. When you have finished writing your assessment tool every one of these must have been addressed, preferably several times in a variety of contexts. To ensure this occurs download the assessment matrix for the unit; enter each assessment task as a column header and place check marks against each performance criteria that task addresses.

Observation Checklist

Tasks to be observed according to workplace/college/TAFE policy and procedures, relevant legislation and Codes of Practice	Yes	No	Comments/feedback
Identify and follow work health and safety, legislative and organisational requirements
Read documentation and identify work requirements and process
Select and check tools, equipment and materials for suitability, serviceability and safety prior to use
Confirm sub-floor suitability for installation consistent with Australian Standards and manufacturer recommendations
Select suitable adhesives, trims and accessories in accordance with work requirements
Plan sequence of work, including the starting point, to ensure efficiency and quality of installation
Check synthetic floor covering material to be installed against work order and acclimatise in accordance with manufacturer recommendations
Cut and lay required shock padding / underlays for synthetic turf floor coverings to specification
Establish working lines and starting point
Prepare adhesives and edge strips for use in accordance with job requirements
Identify and follow instructions and sequence for laying and fixing
Organise and use materials for fixing in accordance with safety management requirements
Lay out synthetic floor coverings to meet pattern and specification requirements and to minimise waste and joins
Accurately and clearly mark synthetic floor coverings for cutting
Cut synthetic floor coverings to length and cut joins in preparation for final laying
Join synthetic floor coverings using adhesive and seam tape to in accordance with manufacturer instructions
Complete required line marking in accordance with specification
Fit and finish cover trims to required standards
Check completed installation for flaws in installation and rectify materials and faults
Store and recycle unused materials in accordance with workplace procedures
Check, clean and store tools and equipment in accordance with workplace procedures
Clean work area and dispose of rubbish safely
Accurately complete required workplace documentation

Assessment Cover Sheet

MSFFL3063 - Install synthetic textile floor coverings to sports facilities and outdoor spaces

Assessment task 1: [title]

Student name:

Student ID:

I declare that the assessment tasks submitted for this unit are my own work.

Student signature:

Result: Competent Not yet competent

Feedback to student

 

 

 

 

 

 

 

 

Assessor name:

Signature:

Date:

Assessment Record Sheet

MSFFL3063 - Install synthetic textile floor coverings to sports facilities and outdoor spaces

Student name:

Student ID:

Assessment task 1: [title] Result: Competent Not yet competent

(add lines for each task)

Feedback to student:

 

 

 

 

 

 

 

 

Overall assessment result: Competent Not yet competent

Assessor name:

Signature:

Date:

Student signature:

Date: