This unit describes the skills and knowledge required to prepare, set out, cut and lay timber flooring materials to stairs and steps.

This unit applies to flooring technicians installing timber to stairs in accordance with pre-determined work orders.

Licensing, legislative or certification requirements may apply to this unit and relevant state/territory and local government agencies should be consulted to determine any necessary certification or licensing for undertaking flooring work. Industry standards and codes of practice within Australia must also be applied. Access to construction sites requires certification of general induction training specified by the National Code of Practice for Induction for Construction Work (ASCC 2007).

You may want to include more information here about the target group and the purpose of the assessments (eg formative, summative, recognition)

List each assessment task's title, type (eg project, observation/demonstration, essay, assingnment, checklist) and due date here

Assessment task 1: [title]      Due date:

(add new lines for each of the assessment tasks)

Copy and paste from the following data to produce each assessment task. Write these in plain English and spell out how, when and where the task is to be carried out, under what conditions, and what resources are needed. Include guidelines about how well the candidate has to perform a task for it to be judged satisfactory.

Copy and paste from the following performance criteria to create an observation checklist for each task. When you have finished writing your assessment tool every one of these must have been addressed, preferably several times in a variety of contexts. To ensure this occurs download the assessment matrix for the unit; enter each assessment task as a column header and place check marks against each performance criteria that task addresses.

Observation Checklist

Tasks to be observed according to workplace/college/TAFE policy and procedures, relevant legislation and Codes of Practice	Yes	No	Comments/feedback
Identify and follow work health and safety, legislative and organisational requirements
Correctly identify work requirements and process from review of documentation
Confirm subfloor suitability for installation consistent with Australian Standards and manufacturer recommendations
Measure stairway or steps and accurately calculate the required amount flooring materials
Select adhesives, trims and accessories based on job requirements
Select tools and equipment and check prior to use to ensure that they are appropriate for the work, serviceable and in a safe condition
Plan sequence of work, including a starting point, to ensure efficiency and quality of installation
Check timber flooring against work order and acclimatise in accordance with manufacturer recommendations
Use materials in accordance with safety management requirements
Establish working lines and starting point
Follow instructions and sequence for laying and fixing
Lay out materials to meet specifications and minimise waste
Maximise the aesthetics of the materials, including matching grains and colours
Check required underlay against specified type, manufacturer recommendations and fittings
Carry out any remedial work to stairway to ensure finished stairway is consistent with guidelines set out in relevant standards, codes and guidelines
Cut flooring materials in accordance with workplace procedures
Install required underlay in accordance with manufacturer recommendations
Use fixing methods and equipment in accordance with manufacturer recommendations and safety management requirements
Install flooring materials to specifications to the subfloor in accordance with workplace procedures
Check finished stairway for flaws in installation and materials and rectify faults
Store and recycle unused materials in accordance with workplace procedures
Check, clean and store tools and equipment in accordance with workplace procedures
Clean work area and dispose of rubbish safely
Accurately complete required workplace documentation

Assessment Cover Sheet

MSFFL3080 - Install timber flooring materials to stairs

Assessment task 1: [title]

Student name:

Student ID:

I declare that the assessment tasks submitted for this unit are my own work.

Student signature:

Result: Competent Not yet competent

Feedback to student

 

 

 

 

 

 

 

 

Assessor name:

Signature:

Date:

Assessment Record Sheet

MSFFL3080 - Install timber flooring materials to stairs

Student name:

Student ID:

Assessment task 1: [title] Result: Competent Not yet competent

(add lines for each task)

Feedback to student:

 

 

 

 

 

 

 

 

Overall assessment result: Competent Not yet competent

Assessor name:

Signature:

Date:

Student signature:

Date: