This unit describes the skills and knowledge required to identify work requirements, prepare tools and materials, and install flat and curved glazing products in commercial environments such as shopfronts, doors and windows.

This unit applies to individuals installing products. They may or may not also fabricate the products.

Licensing, legislative or certification requirements may apply to this unit and relevant state/territory and local government agencies should be consulted to determine any necessary certification or licensing for undertaking glass and glazing work. Access to construction sites requires certification of general induction training specified by the National Code of Practice for Induction for Construction Work (ASCC 2007).

You may want to include more information here about the target group and the purpose of the assessments (eg formative, summative, recognition)

List each assessment task's title, type (eg project, observation/demonstration, essay, assingnment, checklist) and due date here

Assessment task 1: [title]      Due date:

(add new lines for each of the assessment tasks)

Copy and paste from the following data to produce each assessment task. Write these in plain English and spell out how, when and where the task is to be carried out, under what conditions, and what resources are needed. Include guidelines about how well the candidate has to perform a task for it to be judged satisfactory.

Copy and paste from the following performance criteria to create an observation checklist for each task. When you have finished writing your assessment tool every one of these must have been addressed, preferably several times in a variety of contexts. To ensure this occurs download the assessment matrix for the unit; enter each assessment task as a column header and place check marks against each performance criteria that task addresses.

Observation Checklist

Tasks to be observed according to workplace/college/TAFE policy and procedures, relevant legislation and Codes of Practice	Yes	No	Comments/feedback
Read work documentation and identify installation requirements
Identify and follow work health and safety requirements
Determine required installation methods and materials, and estimate quantities
Plan a logical work sequence suited to the job and workplace procedures
Select and check tools and equipment for suitability, serviceability and safety prior to use
Select and confirm type and quantity of components and materials against specifications
Measure and prepare components and materials using required tools in accordance with specifications
Consult customer and obtain permission prior to site inspection
Identify site safety hazards and take corrective action to reduce injury to self and others
Identify other on-site characteristics for their impact on the installation process
Take accurate measurements and confirm against job specification
Apply covering material to protect existing fixtures and fittings in accordance with workplace procedures
Remove glass in accordance with safety and work requirements
Assess frame and/or opening to ensure suitability for re-glazing in accordance with customer requirements and Australian Standards
Report defective frames for repair or replacement in accordance with workplace procedures
Prepare frame and/or opening to receive glass through check of size against specifications, removal of sealant remains and surface preparation
Prepare fixing and sealing materials by mixing or cutting to length in accordance with job requirements
Fix glass to the frame using the selected method and in accordance with recognised industry procedures and Australian Standards
Use solvents and sealants in accordance with manufacturer recommendations and Australian Standards
Remove excess sealing material and clean glass and frame after fixing
Check completed installation for compliance with customer requirements, specifications and Australian Standards
Clean and store tools, equipment and materials in accordance with workplace procedures
Clean work area, leave in a safe condition and dispose of waste or recycle in accordance with workplace protocols
Accurately complete required workplace documentation

Assessment Cover Sheet

MSFGG3036 - Install commercial glazing products

Assessment task 1: [title]

Student name:

Student ID:

I declare that the assessment tasks submitted for this unit are my own work.

Student signature:

Result: Competent Not yet competent

Feedback to student

 

 

 

 

 

 

 

 

Assessor name:

Signature:

Date:

Assessment Record Sheet

MSFGG3036 - Install commercial glazing products

Student name:

Student ID:

Assessment task 1: [title] Result: Competent Not yet competent

(add lines for each task)

Feedback to student:

 

 

 

 

 

 

 

 

Overall assessment result: Competent Not yet competent

Assessor name:

Signature:

Date:

Student signature:

Date: