This unit describes the skills and knowledge required to replace glass in commercial and structural applications.

This unit applies to glaziers working in accordance with pre-determined work orders.

Licensing, legislative or certification requirements may apply to this unit and relevant state/territory and local government agencies should be consulted to determine any necessary certification or licensing for undertaking glass and glazing work. Industry standards and codes of practice within Australia must also be applied. Access to construction sites requires certification of general induction training specified by the National Code of Practice for Induction for Construction Work (ASCC 2007).

You may want to include more information here about the target group and the purpose of the assessments (eg formative, summative, recognition)

List each assessment task's title, type (eg project, observation/demonstration, essay, assingnment, checklist) and due date here

Assessment task 1: [title]      Due date:

(add new lines for each of the assessment tasks)

Copy and paste from the following data to produce each assessment task. Write these in plain English and spell out how, when and where the task is to be carried out, under what conditions, and what resources are needed. Include guidelines about how well the candidate has to perform a task for it to be judged satisfactory.

Copy and paste from the following performance criteria to create an observation checklist for each task. When you have finished writing your assessment tool every one of these must have been addressed, preferably several times in a variety of contexts. To ensure this occurs download the assessment matrix for the unit; enter each assessment task as a column header and place check marks against each performance criteria that task addresses.

Observation Checklist

Tasks to be observed according to workplace/college/TAFE policy and procedures, relevant legislation and Codes of Practice	Yes	No	Comments/feedback
Identify work requirements for the type of glass to be used and the method of fixing from work documentation and communication with the customer
Identify and follow work health and safety requirements for commercial reglazing
Plan a logical work sequence suited to the job and workplace procedures
Take accurate site measurements and establish clearance and wedge requirements
Select glass and frames to match job requirements and check for type, size and imperfections against job requirements and relevant Australian Standards
Select glass fixing method to meet specifications
Select and check tools and equipment for suitability, serviceability and safety prior to use
Consult customer and obtain permission prior to site inspection
Identify site safety hazards and take corrective action to reduce injury to self and others
Identify other on-site characteristics for their impact on the installation process
Take accurate site measurements and confirm against job specification
Protect existing fixtures and fittings through the application of suitable coverings
Remove glass in accordance with safety requirements
Assess frame condition to ensure suitability for reglazing in accordance with Australian Standards
Report defective frames for repair or replacement in accordance with workplace procedures
Prepare frame to receive glass in accordance with specifications
Prepare fixing and sealing materials by mixing or cutting to length, in accordance with job requirements
Safely cut glass using appropriate equipment in accordance with specific job requirements
Fix glass to the frame using the selected method in accordance with workplace procedures and Australian Standards
Use solvents and sealants in accordance with manufacturer recommendations and Australian Standards
Remove excess sealing material and clean glass and frame with suitable cleaning agents after fixing
Check completed installation for compliance with customer requirements, specifications and Australian Standards
Clean and store tools, equipment and materials in accordance with workplace procedures
Clean work area and leave in a safe condition and dispose of waste or recycle in accordance with workplace protocols
Accurately complete required workplace documentation

Assessment Cover Sheet

MSFGG3038 - Conduct commercial and structural reglazing

Assessment task 1: [title]

Student name:

Student ID:

I declare that the assessment tasks submitted for this unit are my own work.

Student signature:

Result: Competent Not yet competent

Feedback to student

 

 

 

 

 

 

 

 

Assessor name:

Signature:

Date:

Assessment Record Sheet

MSFGG3038 - Conduct commercial and structural reglazing

Student name:

Student ID:

Assessment task 1: [title] Result: Competent Not yet competent

(add lines for each task)

Feedback to student:

 

 

 

 

 

 

 

 

Overall assessment result: Competent Not yet competent

Assessor name:

Signature:

Date:

Student signature:

Date: