This unit of competency describes the skills and knowledge to prepare test specimens and perform multi-stage mechanical tests on them. The unit requires personnel to create test conditions that suit the materials intended use, optimise measurement procedures and recognise critical measurement points during the tests. The unit also covers data analysis and troubleshooting procedures/equipment that have led to atypical data or results.

This unit applies to laboratory personnel in the construction materials, mining and manufacturing industry sectors.

No licensing or certification requirements exist at the time of publication. However, regulations and/or external accreditation requirements for laboratory operations exist, so local requirements should be checked. Relevant legislation, industry standards and codes of practice within Australia must also be applied.

You may want to include more information here about the target group and the purpose of the assessments (eg formative, summative, recognition)

List each assessment task's title, type (eg project, observation/demonstration, essay, assingnment, checklist) and due date here

Assessment task 1: [title]      Due date:

(add new lines for each of the assessment tasks)

Copy and paste from the following data to produce each assessment task. Write these in plain English and spell out how, when and where the task is to be carried out, under what conditions, and what resources are needed. Include guidelines about how well the candidate has to perform a task for it to be judged satisfactory.

Copy and paste from the following performance criteria to create an observation checklist for each task. When you have finished writing your assessment tool every one of these must have been addressed, preferably several times in a variety of contexts. To ensure this occurs download the assessment matrix for the unit; enter each assessment task as a column header and place check marks against each performance criteria that task addresses.

Observation Checklist

Tasks to be observed according to workplace/college/TAFE policy and procedures, relevant legislation and Codes of Practice	Yes	No	Comments/feedback
Position and secure test specimen in test equipment/instrument
Conduct preliminary measurements to determine optimum test conditions and instrument settings
Perform each measurement stage in sequence, terminating each stage at the appropriate end point
Record all test measurements, observations and factors that may impact on quality of results
Remove test piece and conduct post-test measurements
Shut down equipment and store used test pieces in accordance with workplace procedures
Review test request and sample documentation to identify required test parameters and intended use of bulk material
Prepare test specimens in accordance with test method
Set up equipment/instruments in accordance with test method
Position and secure test specimen in test equipment/instrument
Confirm data is the result of valid measurements
Make entries on report forms or into a laboratory information management system accurately calculating, recording or transcribing data as required

Assessment Cover Sheet

MSL975044 - Perform complex tests to measure engineering properties of materials

Assessment task 1: [title]

Student name:

Student ID:

I declare that the assessment tasks submitted for this unit are my own work.

Student signature:

Result: Competent Not yet competent

Feedback to student

 

 

 

 

 

 

 

 

Assessor name:

Signature:

Date:

Assessment Record Sheet

MSL975044 - Perform complex tests to measure engineering properties of materials

Student name:

Student ID:

Assessment task 1: [title] Result: Competent Not yet competent

(add lines for each task)

Feedback to student:

 

 

 

 

 

 

 

 

Overall assessment result: Competent Not yet competent

Assessor name:

Signature:

Date:

Student signature:

Date: