Elements and Performance Criteria
- Prepare for work
- Work instructions are used to determine job requirements, including quality, material, equipment quantities and service manuals
- Job specifications are read and interpreted
- OHS requirements, including personal protection needs, are observed throughout the work
- Electronic system protection devices, processes and precautions are identified appropriate to the application
- Equipment and tooling are identified and checked for safety and correct operation
- Procedures are identified to minimise task time
- Test control system, diagnose faults and determine service/repair requirements
- Correct information is accessed and interpreted from manufacturer/component supplier specifications
- Tests are carried out according to manufacturer/component supplier recommended procedures using tooling, equipment and techniques
- Testing is completed without causing damage to component or system
- Testing is carried out according to industry regulations/ guidelines, OHS and enterprise procedures
- Tests results are used to diagnose system/component faults
- Service/repair requirements are determined
- Service/repair electronic stability control systems
- Correct information is accessed and interpreted from manufacturer/component supplier specifications
- Service/repair requirements are carried out according to manufacturer/component supplier recommended specifications and procedures
- Service/repair is completed without causing damage to component or system
- Service/repairs are carried out according to industry regulations/guidelines, OHS and enterprise/procedures policies
- Clean up work area and maintain equipment
- Material that can be reused is collected and stored
- Waste and scrap is removed following workplace procedures
- Equipment and work area are cleaned and inspected for serviceable conditions in accordance with workplace procedures
- Unserviceable equipment is tagged and faults identified in accordance with workplace procedures
- Operator maintenance is completed in accordance with manufacturer/component supplier specifications and site procedures
- Tooling is maintained in accordance with workplace procedures