Elements and Performance Criteria
- Prepare for work
- Check and test wiring harness and loom assembly
- Wiring harness and looms are visually checked to establish the extent of damage
- Options for diagnosing faults are used, using appropriate tools and diagnostic techniques
- Components or systems are checked without causing damage to components or systems as a result of inappropriate testing procedures
- Faults are identified and preferred repair action is determined
- Remove, replace and label wiring harness and loom
- Correct information is accessed and interpreted from manufacturer and component supplier specifications
- Wiring harness and loom are labelled and removed using tools and techniques
- Associated components are labelled, removed and tagged for storage
- Repaired and fabricated harness and loom are correctly refitted to vehicle and reconnected according to manufacturer and component supplier specifications
- Removal, replacement and labelling are completed according to industry regulations and guidelines, and WHS and workplace policies and procedures, and without causing damage to components or systems
- Repair wiring harness and loom
- Correct information is accessed and interpreted from manufacturer and component supplier specifications
- Repair options are carried out using tools, diagnostic techniques and materials
- Repairs are carried out according to industry regulations and guidelines, and WHS and workplace policies and procedures
- Fabricate wiring harness and loom
- Electrical circuit wiring diagrams are accessed and interpreted from manufacturer and component supplier specifications
- Harness and loom are fabricated to approved specifications using tools and contemporary fabrication techniques and materials
- Post-repair testing of the harness and loom is conducted and results are documented according to workplace policies and procedures
- Clean up work area and maintain equipment
- Workplace documents are completed according to site requirements
- Material that can be reused is collected and stored
- Waste and scrap are removed following workplace procedures
- Tools, equipment and work area are cleaned, inspected for serviceable condition, and maintained according to workplace procedures
- Faulty equipment is identified, tagged and isolated according to workplace procedures
- Operator maintenance is completed according to manufacturer and component supplier specifications and site procedures