Elements and Performance Criteria
- Prepare to test and inspect battery
- Nature and scope of work requirements are identified and confirmed
- Workplace health and safety (WHS) requirements, including individual state and territory regulatory requirements and personal protective equipment (PPE) needs, are observed throughout the work
- Safe operating procedures and information such as site procedures and specifications are sourced
- Technical information is accessed from manufacturer and component supplier specifications and interpreted
- Tools, equipment and materials are identified and prepared
- Warnings in relation to working with batteries are observed
- Test and service battery
- Service and maintenance methods are carried out according to workplace procedures and manufacturer and component supplier specifications
- Electrolyte levels are checked and topped up where appropriate according to service and maintenance methods
- Batteries and terminals are cleaned according to site procedures
- Battery voltage and load checks are conducted to confirm service repair action
- Battery is charged, jump-started or replaced
- Charge battery
- Technical information for charging is accessed from manufacturer and component supplier specifications and is correctly interpreted
- Components, tools and equipment to complete work are identified, selected and prepared according to site procedures
- Electrolyte levels are checked and topped up according to site procedures
- Batteries are charged according to site procedures and component manufacturer and supplier recommendations
- Carry out jump-start procedures to vehicle
- Technical information is accessed from manufacturer and component supplier specifications and is correctly interpreted
- Battery voltage is identified and vehicle and equipment are confirmed as being appropriate to jump-start procedures
- Leads are connected and disconnected in correct sequence and polarity
- Work is carried out without causing damage to the vehicles involved and equipment being used
- Remove and replace battery
- Battery is removed from vehicle according to site procedures, and component manufacturer and supplier recommendations
- Battery is replaced in line with vehicle electrical and physical specifications and measurements
- Correct secure battery fitment is confirmed
- Battery terminals are reconnected and tightened
- Retest battery
- Prepare vehicle and equipment for delivery to customer after battery is replaced
- Clean up work area and maintain equipment
- Material that can be reused or recycled is collected and stored according to workplace sustainability practices
- Waste and scrap are removed according to workplace practices
- Tools, equipment and work area are cleaned and inspected according to workplace procedures
- Tools and equipment are maintained according to workplace procedures
- Faulty equipment is identified, tagged and isolated according to workplace procedures