Elements and Performance Criteria
- Prepare for work
- Work instructions are used to determine job requirements, including method, material and equipment.
- Job specifications are read and interpreted.
- Occupational health and safety (OHS) requirements, including personal protection needs are observed throughout the work.
- Material for the work is selected.
- Equipment and tooling are identified and checked for safe and effective operation.
- Procedures are determined to minimise waste material.
- Procedures are identified for maximising energy efficiency while completing the job.
- Remove protector mouldings, transfers and decals
- Information is accessed and interpreted from manufacturer/component supplier specifications.
- Work is completed without causing damage to component, system or protector mouldings, transfers and decals.
- Removal activities are carried out according to industry regulations/guidelines, OHS requirements, legislation and enterprise procedures/policies.
- Prepare for replacement/ fitting of protector mouldings, transfers and decals
- Information is accessed and interpreted from manufacturer/ component supplier specifications.
- Protector mouldings, transfers and decals to be fitted are within specifications for dimensions, material and functional capability.
- Adhesives are selected according to the product manufacturer/component supplier specification for type, method, application and thickness.
- Work is completed without causing damage to component, system or protector mouldings or transfers and decals.
- Reusable moulds, decals and attachment clips/components are inspected and cleaned in preparation for refitting.
- Replace/fit protector mouldings, transfers and decals
- Information is accessed and interpreted from manufacturer/component supplier specifications.
- Protector mouldings, transfers and decals are replaced and fitted using approved methods, material and equipment.
- Adhesives are applied according to the product manufacturer/component supplier specifications for type, method, application and thickness.
- Work is completed without causing damage to component, system or protector mouldings, transfers and decals.
- Replacement/refitting activities are carried out according to industry regulations/guidelines, OHS requirements, legislation and enterprise procedures/policies.
- Clean up work area and maintain equipment
- Material that can be reused is collected and stored
- Waste and scrap is removed following workplace and environmental procedures.
- Equipment and work area are cleaned and inspected for serviceable condition in accordance with workplace procedures.
- Unserviceable equipment is tagged and faults identified in accordance with workplace requirements.
- Operator maintenance is completed in accordance with manufacturer/component supplier specifications and worksite procedures.
- Tooling is maintained in accordance with workplace procedures.