Elements and Performance Criteria
- Prepare for work
- Work instructions are used to determine the work requirements, including method, materials and equipment.
- Job specifications are read and interpreted.
- OH&S requirements, including personal protection needs are observed throughout the work.
- Material for work is selected.
- Equipment and tooling are identified and checked for safe and effective operation.
- Procedures are determined to minimise waste material.
- Procedures are identified for maximising energy efficiency while completing the work.
- Inspect and identify paint faults and determine restoration procedure
- Inspection, identification and determination of procedures are completed without causing further damage to paint or components.
- Inspection and identification procedures are carried out according to workplace methods and procedures.
- Restoration process is determined according to type of damage, paint type and finish, workplace and industry/ product manufacturer/component supplier prescribed methods and procedures.
- Restore vehicle body exterior finishing material
- Equipment is selected and used according to workplace methods and customer requirements.
- Restoration materials are selected according to type of damage and type of finishing material, workplace methods and paint manufacturer/component supplier recommendations.
- Vehicle body exterior finish is restored according to industry standards/regulations/guidelines, OH&S legislation, and enterprise procedures/policies.
- Restoration is completed without causing damage to any component or system.
- Materials are used and stored according to manufacturer/ component supplier recommendations and regulatory requirement.
- Clean up work area and maintain equipment
- Material that can be reused is collected and stored.
- Waste material is removed following workplace and environmental procedure.
- Equipment and work area are cleaned and inspected for serviceable condition in accordance with workplace procedures.
- Unserviceable equipment is tagged and faults identified in accordance with workplace requirements.
- Operator maintenance is completed in accordance with manufacturer/component supplier specifications and worksite procedures.
- Tooling is maintained in accordance with workplace procedures.