Elements and Performance Criteria
- Prepare for work
- Work instructions are used to determine the job requirements, including method, materials and equipment.
- Job specifications are read and interpreted.
- WHS requirements, including dust and fume collection, breathing apparatus, eye and ear personal protection needs are observed throughout the work.
- Material for repair is selected.
- Equipment and tooling are identified and checked for safe and effective operation.
- Procedures are determined to minimise waste material.
- Procedures are identified for maximising energy efficiency while completing the job.
- Remove welded panels/panel sections
- Information is accessed and interpreted from manufacturer/component supplier specifications.
- Protective equipment appropriate to repair activities is used.
- Components are removed using approved methods and equipment in accordance with manufacturer/component supplier specification.
- Where removal of components includes disturbance to electrical, mechanical, air conditioning systems or trim, authorised assistance is sought.
- Removal activities are carried out according to industry regulations/guidelines, WHS legislation, and enterprise procedures/policies.
- Replace and align welded panel/panel sections
- Information is accessed and interpreted from manufacturer/component supplier specifications.
- Protective equipment appropriate to repair activities is used.
- Components are replaced and aligned using approved methods and equipment in accordance with manufacturer/ component supplier specifications.
- Where replacement of components includes disturbance to electrical, mechanical, air conditioning systems or trim, authorised assistance is sought.
- Replacements are carried out to pre-paint condition.
- Replacement and alignment activities are carried out according to industry regulations/guidelines, WHS legislation, and enterprise procedures/policies.
- Workplace/equipment documentation is completed and dealt with relevant to work outcomes.
- Clean up work area and maintain equipment
- Material that can be reused is collected and stored.
- Waste and scrap is removed following workplace and environmental procedures.
- Equipment and work area are cleaned and inspected for serviceable condition in accordance with workplace procedures.
- Unserviceable equipment is tagged and faults identified in accordance with workplace requirements.
- Operator maintenance is completed in accordance with manufacturer/component supplier specifications and worksite procedures.
- Tooling is maintained in accordance with workplace procedures.