Elements and Performance Criteria
- Prepare for work
- Work instructions are used to determine job requirements, including method, material and equipment.
- Job specifications are read and interpreted.
- WHS requirements, including personal protection needs are observed throughout the work.
- Materials for repair are selected.
- Equipment and tooling are identified and checked for safe and effective operation.
- Procedures are determined to minimise waste material.
- Procedures are identified for maximising energy efficiency while completing the job.
- Inspect and test vehicle body component seals for leaks
- Information is accessed and applied in accordance with vehicle/component manufacturer/component supplier specifications.
- Inspection and testing, including those for water and dust leaks and wind noise, follow industry accepted procedures.
- Inspection and testing procedures are carried out in accordance with manufacturer/component supplier specifications.
- Inspection and testing are completed without causing damage to vehicle section, system or component.
- Activities are carried out according to industry regulations/ guidelines, WHS, legislation and enterprise procedures/ policies.
- Install, repair and/or replace vehicle body component seals
- Information is accessed and applied in accordance with vehicle/component manufacturer/component supplier specifications.
- Fittings, tooling and equipment are used.
- Installation, repairs and replacement procedures are carried out in accordance with manufacturer/component supplier specifications.
- Work is completed without causing damage to vehicle section, system or component.
- Activities are carried out according to industry regulations/ guidelines, WHS, legislation and enterprise procedures/ policies.
- Workplace equipment documentation is completed and processed to enterprise/manufacturer/component supplier requirements.
- Clean up work area and maintain equipment
- Material that can be reused is collected and stored.
- Waste and scrap is removed following workplace and environmental procedures.
- Equipment and work area are cleaned and inspected for serviceable condition in accordance with workplace procedures.
- Unserviceable equipment is tagged and faults identified in accordance with workplace requirements.
- Operator maintenance is completed in accordance with manufacturer/component supplier specifications and worksite procedures.
- Tooling is maintained in accordance with workplace procedures.