Elements and Performance Criteria
- Prepare for work
- Work instructions are used to determine job requirements, including required method of application, and type of film-wrapping material and equipment
- Workplace health and safety (WHS) requirements are identified and followed
- Film wrapping and other necessary materials are selected
- Tools and equipment are identified, checked and used correctly
- Application procedures are determined to minimise mistakes and waste and maximise energy efficiency while completing the job
- Vehicle panel surface is assessed for quality
- Measure and cut film-wrapping materials
- Film supplier specifications are accessed and interpreted
- Measurement, cutting and template production are performed according to film supplier specifications, industry regulations and guidelines, WHS requirements, statutory and regulatory authority requirements, and workplace procedures
- Surfaces are measured, material patterns and templates are produced, and cut is made without causing damage to vehicle body surface
- Workplace documents are completed relevant to film size cutting and application outcomes
- Prepare vehicle surface and apply film-wrapping material
- Surface is prepared using approved methods, materials and equipment, according to the specifications of film-wrapping material
- Film-wrapping materials are applied according to supplier specifications and quality requirements
- Film-wrapping applications are inspected and tested according to suppliers’ recommended procedures
- Film-wrapping applications are completed without causing damage to vehicle and according to industry regulations and guidelines, WHS requirements and workplace policies and procedures
- Workplace documents are completed
- Clean up work area and maintain equipment
- Material that can be reused is collected and stored according to workplace sustainability practices
- Waste and scrap are removed following workplace and environmental procedures
- Equipment and work area are cleaned and inspected for serviceable condition according to workplace procedures
- Faulty equipment is identified and tagged according to workplace requirements
- Workplace emergency procedures are identified and followed when required
- Tools are maintained according to workplace procedures