Elements and Performance Criteria
- Prepare for fabrication work
- Information for work is accessed from manufacturer/ component supplier specifications and interpreted.
- WHS requirements, including personal protection needs, are observed throughout the work.
- Materials are selected and inspected for quality.
- Components, tooling and equipment for fabrication and installation are identified, selected and prepared in accordance with worksite procedures.
- Procedures are determined to minimise waste material.
- Procedures are identified for maximising energy efficiency while completing the job.
- Measure, mark out and cut vehicle hood (soft top)
- Information for measuring, marking out and cutting is interpreted and followed.
- Measurements are accessed from manufacturer/component supplier specifications and/or directly measured fitting requirements.
- Marking out and cutting are carried out and completed in accordance with work plan and specifications.
- Measurements, marking out and cutting are checked for conformity to specifications in accordance with worksite procedures.
- Make up/assemble vehicle hood (soft top)
- Information for following production processes is accessed from manufacturer/component supplier specifications, interpreted and followed.
- Make up/assembly of hood (soft top) is carried out and completed in accordance with work plan and specifications.
- Damage to equipment or machinery is avoided.
- Production is checked for conformity to specifications in accordance with worksite procedures.
- Install and fasten vehicle hood (soft top)
- Information for installation and fastening is interpreted and followed.
- Installation and fastening processes and methods are accessed from manufacturer/component supplier specifications and/or determined from existing fitting.
- Installation and fastenings are checked for conformity to manufacturer/component supplier specifications and vehicle operational requirements.
- Clean up work area and maintain equipment
- Material that can be reused is collected and stored.
- Waste and scrap is removed following workplace procedure.
- Equipment and work area are cleaned and inspected for serviceable condition in accordance with workplace procedures.
- Unserviceable equipment is tagged and faults identified in accordance with workplace procedures.
- Operator maintenance is completed in accordance with manufacturer/component supplier specifications and worksite procedures.
- Tooling is maintained in accordance with workplace procedures.