Elements and Performance Criteria
- Conduct dispenser sampling processes
- Fuel samples are taken from dispenser for visual testing during fuelling operations in accordance with workplace procedures and regulatory requirements
- Conduct fueller sampling processes
- Additional samples are taken from fueller after defuelling operations, vehicle washing, maintenance and rain events
- Conduct visual check of fuel samples
- Sample is inspected for free water and dirt particles in accordance with workplace procedures and established manual or automated processes
- Water detector capsules are used to check for suspended water in accordance with manufacturer instructions and workplace procedures
- Results of visual checks are recorded and reported in accordance with workplace procedures and regulatory requirements
- Test membrane filtration (millepore sampling)
- Fuellers are tested independent of test rig by circulating product through delivery hose back to tank to achieve required flow rates
- Bonding leads are attached in accordance with workplace procedures
- Fueller/dispenser delivery hoses are connected to achieve a flow rate of at least 50% of rated flow of filter
- Hydrant dispenser lanyard is connected to pit valve and inlet hose is connected in accordance with workplace procedures
- Colorimetric capsule is loaded in accordance with manufacturer instructions and workplace procedures
- Checks are made to ensure capsule is located in housing with millepore monitor inlet facing upstream
- Apparatus is connected to filter outlet millepore sample connection or nozzle millepore sample point
- Pressure and flow rate are adjusted to workplace specifications
- Calorimetric test samples are drawn monthly in accordance with sampling schedules
- Gravimetric and microbiological tests are drawn every three months in accordance with sampling schedules, ensuring that initial sample is drawn for gravimetric test then gravimetric capsule is replaced with microbiological capsule, and another sample is drawn in accordance with workplace procedures
- Apparatus is disconnected and capsule is removed
- Gravimetric and microbiological samples are labelled and dispatched to laboratory in accordance with workplace procedures
- Colorimetric assessment is conducted in accordance with manufacturer instructions and workplace procedures
- Test results are documented in accordance with workplace procedures and regulatory requirements
- Measure pressure differential on filter vessels
- Flow through vessel into aircraft or test rig is started in accordance with workplace procedures
- Pressure differential at maximum flow rate obtained is read
- Results are analysed and recorded in accordance with workplace procedures and regulatory requirements
- Where differential pressure exceeds filter manufacturer recommended differential pressure at flow rates above 50% of the maximum rated flow of filter vessel, situation is reported immediately to supervisor for investigation in accordance with workplace procedures and regulatory requirements