Elements and Performance Criteria
- Prepare for work.
- Plans and specifications are obtained.
- Safety (OHS) requirements associated with installing and fitting off sanitary fixtures, and workplace environmental requirements, are adhered to throughout the work.
- Quality assurance requirements are identified and adhered to in accordance with workplace requirements.
- Tasks are planned and sequenced in conjunction with others involved in or affected by the work and statutory and regulatory authority requirements.
- Tools and equipment, including personal protective equipment, are selected and checked for serviceability.
- Work area is prepared to support efficient installation and fitting off of sanitary fixtures.
- Identify installation requirements.
- Position of sanitary fixtures is determined in accordance with plans, specifications and site requirements.
- Quantity and type of materials, including pipe materials required, are calculated from design drawings and specifications.
- Materials and equipment are identified, ordered and collected in accordance with workplace procedures.
- Materials and equipment are checked for compliance with relevant Australian standards, docket and order form, and for acceptable condition.
- Sustainability principles and concepts are applied to work preparation and application.
- Install and fit off sanitary fixtures.
- Set out is checked for compliance with design drawings, manufacturers' instructions, relevant authority requirements and information.
- Fixtures are positioned and installed to comply with plans, specifications and manufacturer requirements.
- Fixtures, components and pipework are assembled, installed and tested to manufacturer requirements, job specification and relevant Australian standards.
- Fixtures are installed and connected without damage or distortion to fixture, pipework, surrounding environment or other services.
- Completed installation is checked for correct functioning and compliance with specifications.
- Clean up.
- Work area is cleared, with materials disposed of, reused or recycled according to legislation, regulations, codes of practice and job specification.
- Tools and equipment are cleaned, checked, maintained and stored in accordance with manufacturer recommendations and workplace procedures.
- Documentation is completed in accordance with workplace requirements.