Google Links
Follow the links below to find material targeted to the unit's elements, performance criteria, required skills and knowledge
Elements and Performance Criteria
- Complete work
- Plan and prepare for work
- Work, Health and Safety (WHS)/Occupational Health and Safety (OHS) regulations, legislative requirements, industry standards, codes of practice, manufacturers’ specifications, environmental obligations and workplace procedures are reviewed in preparation for work
- Resources are obtained and inspected for compliance with job specification
- Relevant plans, drawings and manuals are selected and used, in accordance with workplace procedures
- Correct materials and components for work are obtained and inspected, in accordance with workplace procedures, for compliance with job specification
- Work is planned, sequenced and prioritised, in accordance with workplace procedures
- Potential hazards are identified and risk control measures are selected and implemented, in accordance with workplace procedures
- Work area is prepared, in accordance with workplace procedures
- Conduct in-service testing
- Faults are located using appropriate tools, equipment and testing techniques, in accordance with workplace procedures
- Testing and fault finding results are analysed, in accordance with workplace procedures, to establish repairs required or serviceability of material feeder
- Remove equipment to facilitate maintenance
- Material feeders are disconnected, in accordance with the workplace procedures
- Material feeders are removed, in a manner which will assist in replacement, in accordance with workplace procedures
- Material feeders are inspected for abnormalities, in accordance with workplace procedures
- Maintain material feeders
- Components or subassemblies are dismantled, cleaned and examined, in accordance with workplace procedures, to verify tolerances and to determine whether to replace, overhaul or repair
- Material feeder equipment is dismantled, in a manner that will facilitate reassembly, in accordance with workplace procedures
- Component parts are clearly marked for identification, in accordance with workplace procedures
- Components are laid out, in preparation for reassembly, in accordance with workplace procedures and manufacturers' drawings or specifications
- New components are inspected for compliance with manufacturers' specification and are prepared for assembly, in accordance with workplace procedures
- Modifications or alterations are undertaken, in accordance with workplace procedures
- Components are reassembled, in accordance with workplace procedures
- Replaceorinstall material feeders
- All fastenings are torqued, in accordance with workplace procedures and manufacturers' specifications
- Material feeders are given a test run and are monitored, as required, in accordance with workplace procedures and manufacturers' specification
- Work area is cleared of waste, cleaned, restored and secured, in accordance with workplace procedures
- Tools and equipment are cleaned, maintained and stored, in accordance with workplace procedures
- Work completion details are finalised, in accordance with workplace procedures
Range Statement