Google Links

Follow the links below to find material targeted to the unit's elements, performance criteria, required skills and knowledge

Elements and Performance Criteria

1. Complete work
   • Work is completed, in accordance with workplace procedures
   • Appropriate personnel are notified, in accordance with workplace procedures
2. Plan and prepare for work
   • Requirements including scope of work and assigned roles are identified and confirmed with appropriate personnel or by site inspection, in accordance with workplace procedures
3. Work, Health and Safety (WHS)/Occupational Health and Safety (OHS) regulations, legislative requirements, industry standards, codes of practice, manufacturers’ specifications, environmental obligations and workplace procedures are reviewed in preparation for work
4. Resources are obtained and inspected for compliance with job specification
5. Relevant plans, drawings and manuals are selected and interpreted, in accordance with workplace procedures
6. Correct materials and components for work are obtained and inspected, in accordance with workplace procedures for compliance with job specification
7. Work is planned, sequenced and prioritised, in accordance with workplace procedures and system requirements
8. Potential hazards are identified and risk control measures are selected and implemented, in accordance with workplace procedures
9. Work area is prepared, in accordance with workplace procedures
10. Verify electrical or electronicfault
    • Normal performance and function of electrical and electronic systems is ascertained, in accordance with workplace procedures
11. Fault indicators, technical information and diagnostic techniques are used to verify reported faults, in accordance with workplace procedures
12. Faults are reproduced and monitored, if possible, in accordance with workplace procedures
13. Find electrical or electronicfault
    • Isolations are confirmed, where appropriate, in accordance with workplace procedures and site requirements
14. Electrical and electronic equipment, components, wires, cables, terminations and support fixings are inspected, in accordance with workplace procedures, for faults
15. Diagnostic techniques are selected and used to determine faults, in accordance with workplace procedures
16. Electrical and electronic equipment and components are disconnected, in accordance with workplace procedures, to enable accurate test measurements without back feed readings
17. Test and measurement instruments are used, in accordance with workplace procedures and manufactures' specifications
18. Determine cause of electrical or electronicfault
    • Details relating to fault is collected from personnel, in accordance with workplace procedures
19. Information from indicators and maintenance records are used to determine faults, in accordance with workplace procedures
20. Conclusions about the nature and cause of the fault based on analysis of evidence are used, in accordance with the workplace procedures
21. Repair electrical or electronicfault
    • Isolations are confirmed, where appropriate, in accordance with workplace procedures
22. Faulty, worn or damaged equipment and components are replaced or repaired, in accordance with workplace procedures
23. Equipment and components disconnected for testing are reconnected, in accordance with workplace procedures, and all terminations are checked to ensure they are electrically and mechanically sound
24. All faults are repaired, in accordance with workplace procedures
25. Final inspection is performed, in accordance with workplace procedures
    • Work is completed, in accordance with workplace procedures
26. Appropriate personnel are notified, in accordance with workplace procedures

Range Statement

Range is restricted to essential operating conditions and any other variables essential to the work environment. Non-essential conditions may be found in the Companion Volume Implementation Guide.

---