List each assessment task's title, type (eg project, observation/demonstration, essay, assignment, checklist) and due date here

Assessment task 1: [title]      Due date:

(add new lines for each of the assessment tasks)

Copy and paste from the following data to produce each assessment task. Write these in plain English and spell out how, when and where the task is to be carried out, under what conditions, and what resources are needed. Include guidelines about how well the candidate has to perform a task for it to be judged satisfactory.

Copy and paste from the following performance criteria to create an observation checklist for each task. When you have finished writing your assessment tool every one of these must have been addressed, preferably several times in a variety of contexts. To ensure this occurs download the assessment matrix for the unit; enter each assessment task as a column header and place check marks against each performance criteria that task addresses.

Observation Checklist

Tasks to be observed according to workplace/college/TAFE policy and procedures, relevant legislation and Codes of Practice	Yes	No	Comments/feedback
Identify machining requirements according to job specifications
Select, fit and use personal protective equipment according to health and safety procedures
Collect and prepare materials to be machined
Set up lathe and tooling for machining operation according to workplace procedures and manufacturer’s guidelines
Conduct pre-operational equipment checks according to operating procedures
Identify and report health and safety hazards and maintenance requirements according to health and safety procedures
Set machining parameters to meet job requirements
Position materials for lathe operation according to operating procedures
Start, operate and shut down the lathe according to operating procedures
Check work for conformance to job specifications
Identify non-conforming components, and correct as required
Undertake basic routine operational maintenance according operating procedures
Ensure the work area is maintained to meet work cleaning standards

Assessment Cover Sheet

FBPSUG2027 - Perform general lathe operations

Assessment task 1: [title]

Student name:

Student ID:

I declare that the assessment tasks submitted for this unit are my own work.

Student signature:

Result: Competent Not yet competent

Feedback to student

 

 

 

 

 

 

 

 

Assessor name:

Signature:

Date:

Assessment Record Sheet

FBPSUG2027 - Perform general lathe operations

Student name:

Student ID:

Assessment task 1: [title] Result: Competent Not yet competent

(add lines for each task)

Feedback to student:

 

 

 

 

 

 

 

 

Overall assessment result: Competent Not yet competent

Assessor name:

Signature:

Date:

Student signature:

Date: