List each assessment task's title, type (eg project, observation/demonstration, essay, assignment, checklist) and due date here

Assessment task 1: [title]      Due date:

(add new lines for each of the assessment tasks)

Copy and paste from the following data to produce each assessment task. Write these in plain English and spell out how, when and where the task is to be carried out, under what conditions, and what resources are needed. Include guidelines about how well the candidate has to perform a task for it to be judged satisfactory.

Copy and paste from the following performance criteria to create an observation checklist for each task. When you have finished writing your assessment tool every one of these must have been addressed, preferably several times in a variety of contexts. To ensure this occurs download the assessment matrix for the unit; enter each assessment task as a column header and place check marks against each performance criteria that task addresses.

Observation Checklist

Tasks to be observed according to workplace/college/TAFE policy and procedures, relevant legislation and Codes of Practice	Yes	No	Comments/feedback
Determine the Gross Vehicle Mass (GVM) and estimate the recovery load on the vehicle using a recognised formula
Identify the rating and labelling of recovery gear
Identify rated recovery points on a vehicle
Determine the appropriate equipment to be used given the GVM, estimated recovery load and the equipment rating
Determine serviceability of recovery equipment required for task
Identify and follow work health and safety procedures, including selection and use of personal protective equipment relevant to recovery operations
Identify, assess and take actions to mitigate risks and hazards associated with recovery operations
Identify and implement workplace environmental protection procedures associated with recovery operations
Identify emergency procedures to follow in the event of accident or incident
Locate and survey site to determine recovery strategy and establishment of an exclusion zone
Inform appropriate personnel of location of vehicle to be recovered and recovery strategy
Establish and maintain communications with appropriate personnel during recovery operation
Establish when and by what means to start and stop the recovery
Lay out the kinetic rope/strap prior to recovery
Fit the kinetic rope/strap to anapprovedrecovery point/device that is suitably rated for use with the strap
Demonstrate the joining of two kinetic ropes and/or straps
Identify where to place dampeners
Perform a safe recovery using the kinetic rope/strap
Establish and maintain communications with appropriate personnel during recovery operation
Establish when and how to start and stop the recovery
Lay out all the equipment to be used, including the dampeners
Perform winch recovery using a single line pull
Perform winch recovery using a double line pull using a snatch block or pulley ring
Perform winch recovery using a change of direction pull using a snatch block or pulley ring
Use a spade for vehicle recovery
Use traction boards for vehicle recovery
Clean, carry out operator maintenance, check serviceability and store recovery equipment after use according to manufacturer requirements
Record equipment maintenance according to workplace procedures

Assessment Cover Sheet

FWPCOT3326 - Recover four wheel drive vehicle

Assessment task 1: [title]

Student name:

Student ID:

I declare that the assessment tasks submitted for this unit are my own work.

Student signature:

Result: Competent Not yet competent

Feedback to student

 

 

 

 

 

 

 

 

Assessor name:

Signature:

Date:

Assessment Record Sheet

FWPCOT3326 - Recover four wheel drive vehicle

Student name:

Student ID:

Assessment task 1: [title] Result: Competent Not yet competent

(add lines for each task)

Feedback to student:

 

 

 

 

 

 

 

 

Overall assessment result: Competent Not yet competent

Assessor name:

Signature:

Date:

Student signature:

Date: