List each assessment task's title, type (eg project, observation/demonstration, essay, assignment, checklist) and due date here

Assessment task 1: [title]      Due date:

(add new lines for each of the assessment tasks)

Copy and paste from the following data to produce each assessment task. Write these in plain English and spell out how, when and where the task is to be carried out, under what conditions, and what resources are needed. Include guidelines about how well the candidate has to perform a task for it to be judged satisfactory.

Copy and paste from the following performance criteria to create an observation checklist for each task. When you have finished writing your assessment tool every one of these must have been addressed, preferably several times in a variety of contexts. To ensure this occurs download the assessment matrix for the unit; enter each assessment task as a column header and place check marks against each performance criteria that task addresses.

Observation Checklist

Tasks to be observed according to workplace/college/TAFE policy and procedures, relevant legislation and Codes of Practice	Yes	No	Comments/feedback
Identify floor installation requirements from job instructions
Select and check all required tools and equipment are ready to use
Gather floor, floor covering and other items required by job specifications, and check they meet quality requirements and are ready for installation
Identify hazards and hazard controls and check the hazard controls are in place and operating
Secure the chassis and check it and the work area are ready for installing the floor
Cut the floor material according to job specifications and workplace procedures
Fabricate and install wheel arches according to workplace procedures
Apply adhesive to the chassis according to manufacturer’s instructions
Lift and align the floor in the correct position using lifting equipment and safe manual handling practices
Fix the floor to the chassis or other support according to workplace procedures
Trim off excess and finish fitting the floor to meet quality requirements
Measure and cut the floor covering according to job instructions
Place, align and fit the floor covering in position
Apply adhesives according to the manufacturer’s instructions and safety requirements
Fix the floor covering to the floor and wheel arches according to workplace procedures
Trim off excess and finish laying the floor covering to meet quality requirements
Clean up the recreational vehicle in readiness for the next task
Clean up the work area, identify items for recycling and dispose of waste
Identify, tag and report any damage to equipment and tools
Check, clean and do routine maintenance on equipment and tools and store them and unused materials
Complete task outcome documentation

Assessment Cover Sheet

MSMRV369 - Install recreational vehicle floors and floor coverings

Assessment task 1: [title]

Student name:

Student ID:

I declare that the assessment tasks submitted for this unit are my own work.

Student signature:

Result: Competent Not yet competent

Feedback to student

 

 

 

 

 

 

 

 

Assessor name:

Signature:

Date:

Assessment Record Sheet

MSMRV369 - Install recreational vehicle floors and floor coverings

Student name:

Student ID:

Assessment task 1: [title] Result: Competent Not yet competent

(add lines for each task)

Feedback to student:

 

 

 

 

 

 

 

 

Overall assessment result: Competent Not yet competent

Assessor name:

Signature:

Date:

Student signature:

Date: