List each assessment task's title, type (eg project, observation/demonstration, essay, assignment, checklist) and due date here

Assessment task 1: [title]      Due date:

(add new lines for each of the assessment tasks)

Copy and paste from the following data to produce each assessment task. Write these in plain English and spell out how, when and where the task is to be carried out, under what conditions, and what resources are needed. Include guidelines about how well the candidate has to perform a task for it to be judged satisfactory.

Copy and paste from the following performance criteria to create an observation checklist for each task. When you have finished writing your assessment tool every one of these must have been addressed, preferably several times in a variety of contexts. To ensure this occurs download the assessment matrix for the unit; enter each assessment task as a column header and place check marks against each performance criteria that task addresses.

Observation Checklist

Tasks to be observed according to workplace/college/TAFE policy and procedures, relevant legislation and Codes of Practice	Yes	No	Comments/feedback
Identify water system rough-in and fit-off requirements from job instructions
Select and check all required tools and equipment are ready to use
Gather water system and other items required by job specifications, and check they meet quality requirements and are ready for installation
Identify hazards and hazard controls and check the hazard controls are in place and operating
Check the recreational vehicle and work area are ready for roughing-in and fitting-off the water system
Confirm the tank locations from the job instructions
Install sensors to the tanks according to workplace procedures
Install tank supports, brackets and tanks according to workplace procedures
Check finished installation according to job instructions and quality requirements and rectify any deficiencies
Run pipes from water sources to fitting-off locations as specified in pipe plans
Cut pipes to length, install joiners and connectors and fasten pipes in position according to workplace procedures
Connect pipes to water sources.
Correctly position and fasten the water system fittings according to job specifications and manufacturer’s instructions
Fit and seal drainage pipes to fit-off items to ensure water tightness
Test the mains water inlet and water pump, and rectify any leaks
Pressure-test pipes and water system fittings, and rectify any leaks
Test drains and rectify any faults or leaks
Clean up the recreational vehicle in readiness for the next task
Clean up the work area, identify items for recycling and dispose of waste
Identify, tag and report any damage to equipment and tools
Check, clean and do routine maintenance on equipment and tools and store them and unused materials
Complete task outcome documentation

Assessment Cover Sheet

MSMRV372 - Rough-in and fit-off recreational vehicle water systems

Assessment task 1: [title]

Student name:

Student ID:

I declare that the assessment tasks submitted for this unit are my own work.

Student signature:

Result: Competent Not yet competent

Feedback to student

 

 

 

 

 

 

 

 

Assessor name:

Signature:

Date:

Assessment Record Sheet

MSMRV372 - Rough-in and fit-off recreational vehicle water systems

Student name:

Student ID:

Assessment task 1: [title] Result: Competent Not yet competent

(add lines for each task)

Feedback to student:

 

 

 

 

 

 

 

 

Overall assessment result: Competent Not yet competent

Assessor name:

Signature:

Date:

Student signature:

Date: