The important thing to remember when gathering evidence is that the more evidence the better - that is, the more evidence you gather to demonstrate your skills, the more confident an assessor can be that you have learned the skills not just at one point in time, but are continuing to apply and develop those skills (as opposed to just learning for the test!). Furthermore, one piece of evidence that you collect will not usualy demonstrate all the required criteria for a unit of competency, whereas multiple overlapping pieces of evidence will usually do the trick!
From the Wiki University
What evidence can you provide to prove your understanding of each of the following citeria?
Prepare for diagnostic procedures
|
|
Nature and scope of work requirements are identified and confirmed Completed |
Evidence:
|
OH&S requirements, including individual State/Territory regulatory requirements and personal protection needs are observed throughout the work Completed |
Evidence:
|
Technical and/or calibration requirements for testing and diagnosis are sourced and support equipment is identified and prepared Completed |
Evidence:
|
Analyse reported faults
|
|
Information is gathered to provide a full overview of faults and conditions under which they occur Completed |
Evidence:
|
Function and operation of the system when operating correctly are identified Completed |
Evidence:
|
Systematic faultfinding processes are used across systems to determine the extent of fault Completed |
Evidence:
|
Additional technical sources are consulted to assist with analysis Completed |
Evidence:
|
Actual faults are distinguished from perceived faults Completed |
Evidence:
|
Identify causes of faults
|
|
Selected diagnostic equipment is prepared for attachment or vehicle use according to manufacturer/component supplier instruction or enterprise standard operating procedures Completed |
Evidence:
|
Vehicle is correctly and safely attached to or on selected diagnostic equipment according to enterprise work practices or standard operating procedures Completed |
Evidence:
|
Calibration or pre-test adjustments are completed according to specific equipment operating procedures before diagnostic tests are carried out Completed |
Evidence:
|
Diagnostic tests are carried out according to enterprise test guidelines to determine location of specific component faults Completed |
Evidence:
|
Source/cause of faults isolated and confirmed Completed |
Evidence:
|
Establish repair requirements
|
|
Viability of repair or replacement is assessed Completed |
Evidence:
|
Repair procedures are identified and prescribed to meet customer service requirements Completed |
Evidence:
|
Repair requirements are clearly and legibly documented and/or communicated to appropriate persons Completed |
Evidence:
|
Repairs involving equipment/skills not held in the workshop are sourced from specialist workshops Completed |
Evidence:
|
Customer is informed of the diagnosis and repair requirements Completed |
Evidence:
|