The important thing to remember when gathering evidence is that the more evidence the better - that is, the more evidence you gather to demonstrate your skills, the more confident an assessor can be that you have learned the skills not just at one point in time, but are continuing to apply and develop those skills (as opposed to just learning for the test!). Furthermore, one piece of evidence that you collect will not usualy demonstrate all the required criteria for a unit of competency, whereas multiple overlapping pieces of evidence will usually do the trick!
From the Wiki University
What evidence can you provide to prove your understanding of each of the following citeria?
Prepare for work
|
|
Work instructions are used to determine job requirements, including quality, material, equipment and quantities. Completed |
Evidence:
|
Job specifications are read and interpreted. Completed |
Evidence:
|
Workplace health and safety (WHS) requirements, including personal protection needs, are observed throughout the work. Completed |
Evidence:
|
Materials for repairs and alterations are selected and inspected for quality. Completed |
Evidence:
|
Hand and power tooling are identified and checked for safe use. Completed |
Evidence:
|
Products are determined to minimise waste material. Completed |
Evidence:
|
Procedures are identified for maximising energy efficiency while completing the job. Completed |
Evidence:
|
Match material
|
|
Information is accessed and interpreted from manufacturer/ component supplier specifications. Completed |
Evidence:
|
Matching procedures are carried out in accordance with manufacturer/component supplier specifications. Completed |
Evidence:
|
Matching procedures are completed within established industry/enterprise guidelines. Completed |
Evidence:
|
Activities are carried out according to industry regulations/ guidelines, WHS requirements, legislation and enterprise procedures policies. Completed |
Evidence:
|
Measure and cut material
|
|
Information is accessed and interpreted from manufacturer/ component supplier specifications. Completed |
Evidence:
|
Measuring and cutting procedures are carried out in accordance with manufacturer/component supplier specifications. Completed |
Evidence:
|
Measuring and cutting procedures are completed within established industry/enterprise guidelines. Completed |
Evidence:
|
Activities are carried out according to industry regulations/ guidelines, WHS requirements, legislation and enterprise procedures/policies. Completed |
Evidence:
|
Fabricate trim/covers to suit vehicle components
|
|
Information is accessed and interpreted from manufacturer/ component supplier specifications. Completed |
Evidence:
|
Trim/cover fabrication procedures are carried out in accordance with manufacturer/component supplier specifications. Completed |
Evidence:
|
Fabrication procedures are completed within established industry/enterprise guidelines. Completed |
Evidence:
|
Activities are carried out according to industry regulations/ guidelines, WHS requirements, legislation and enterprise procedures/policies. Completed |
Evidence:
|
Attach material cover to vehicle/component
|
|
Information is accessed and interpreted from manufacturer/ component supplier specifications. Completed |
Evidence:
|
Attaching procedures are completed in accordance with manufacturer/component supplier specifications and within established industry/enterprise guidelines. Completed |
Evidence:
|
Material is attached without causing damage to component or system. Completed |
Evidence:
|
Activities are carried out according to industry regulations/ guidelines, WHS requirements, legislation and enterprise procedures/policies. Completed |
Evidence:
|
Clean up work area and maintain equipment
|
|
Material that can be reused is collected and stored. Completed |
Evidence:
|
Waste and scrap is removed following workplace procedures. Completed |
Evidence:
|
Equipment and work area are cleaned and inspected for serviceable conditions in accordance with workplace procedures. Completed |
Evidence:
|
Unserviceable equipment is tagged and faults identified in accordance with workplace. Completed |
Evidence:
|
Operator maintenance is completed in accordance with manufacturer/component supplier specifications and worksite procedures. Completed |
Evidence:
|
Tooling is maintained in accordance with workplace procedures. Completed |
Evidence:
|