The important thing to remember when gathering evidence is that the more evidence the better - that is, the more evidence you gather to demonstrate your skills, the more confident an assessor can be that you have learned the skills not just at one point in time, but are continuing to apply and develop those skills (as opposed to just learning for the test!). Furthermore, one piece of evidence that you collect will not usualy demonstrate all the required criteria for a unit of competency, whereas multiple overlapping pieces of evidence will usually do the trick!
From the Wiki University
What evidence can you provide to prove your understanding of each of the following citeria?
Plan and prepare.
|
|
Work instructions and operational details are obtained using relevant information, confirmed and applied for planning and preparation purposes. Completed |
Evidence:
|
Safety (OHS) requirements are followed in accordance with safety plans and policies. Completed |
Evidence:
|
Signage and barricade requirements are identified and implemented. Completed |
Evidence:
|
Tools and equipment selected to carry out tasks are consistent with the requirements of the job, checked for serviceability and any faults are rectified or reported prior to commencement. Completed |
Evidence:
|
Materials quantity requirements are calculated in accordance with plans, specifications and quality requirements. Completed |
Evidence:
|
Materials appropriate to the work application are identified, obtained, prepared, safely handled and located ready for use. Completed |
Evidence:
|
Environmental requirements are identified for the project in accordance with environmental plans and regulatory obligations and applied. Completed |
Evidence:
|
Finishes to be applied to all surfaces are identified in accordance with job requirements, and application that complies with manufacturer specifications. Completed |
Evidence:
|
Prepare new or uncoated surfaces for painting or clear finish.
|
|
Suitability of surface for painting or clear finish application is determined in accordance with manufacturer recommendations and job specifications. Completed |
Evidence:
|
Surface preparation method is correctly selected in accordance with the environment, finish and substrate requirements. Completed |
Evidence:
|
Surface is prepared to manufacturer specifications in compliance with substrate requirements, specifications and relevant standards. Completed |
Evidence:
|
Surface imperfections are stopped, filled and sanded to a smooth finish ready for painting in accordance with manufacturer recommendations and job specifications. Completed |
Evidence:
|
Prepare previously coated surfaces for painting or clear finish.
|
|
Condition and nature of existing substrate and surface material are determined and tested in accordance with relevant standards. Completed |
Evidence:
|
Potential hazards are identified and correct procedures are used to reduce risks in accordance with manufacturer recommendations and job specifications. Completed |
Evidence:
|
Surface preparation method is correctly selected in accordance with the environment, finish and substrate requirements. Completed |
Evidence:
|
Surfaces are prepared by removing unwanted coatings and loose debris. Completed |
Evidence:
|
Surface defects are repaired and imperfections stopped, filled and sanded to smooth finish ready for painting in accordance with manufacturer recommendations and job specifications. Completed |
Evidence:
|
Remove wallpaper and prepare surface for painting.
|
|
Type, condition and nature of existing type of wallpaper are determined prior to removal. Completed |
Evidence:
|
Surface preparation method is correctly selected in accordance with the environment, finish and substrate requirements. Completed |
Evidence:
|
Wallpaper is removed using the most appropriate method. Completed |
Evidence:
|
Surfaces are prepared for paint application by removing loose debris. Completed |
Evidence:
|
Surface defects are repaired and imperfections stopped, filled and sanded to smooth finish ready for painting in accordance with manufacturer recommendations and job specifications. Completed |
Evidence:
|
Clean up.
|
|
Waste and unwanted materials are removed and placed into job waste bins or rubbish stockpile in accordance with sound work practices and compliance with environmental requirements. Completed |
Evidence:
|
Painting tools and equipment are cleaned with correct solutions and without damage, and are stored safely and effectively to manufacturer specifications. Completed |
Evidence:
|
Unused materials are sealed and stored/stacked in accordance with standard material handling practices and techniques and company requirements. Completed |
Evidence:
|
Work area is cleared and materials disposed of or recycled in a manner to avoid spontaneous combustion in accordance with legislation, regulations, codes of practice and job specification. Completed |
Evidence:
|