Prepare for installation of optical fibre cable

1. Access site according to enterprise procedures
2. Inform appropriate personnel of identifiedworksite hazards
3. Organise tools, cabling products, equipment and materials for given work
4. Match optical fibre cabletype and connectors to installation environment and customer requirements
5. Check proposed route and bend ratios according to manufacturer specifications and industry standards
6. Test fibres in the cable on the drum for optical continuity as required
7. Use personal protective equipment, including safety glasses, when working with bare fibre stripping/cleaving and utilise sharps disposal containers for bare fibre off cuts
8. Place fibre patch leads in support pathway, avoiding pressure, crushing and bending

Completed
Date:

Completed
Date:

Completed
Date:

Completed
Date:

Completed
Date:

Completed
Date:

Completed
Date:

Completed
Date:

Clean and inspect connectors

1. Test patch leads, before use, for continuity with a visible light source and inspect and clean connector end faces
2. Test fibre connectors ensuring the circuit has no infra-red transmission (dark fibre)
3. Ensure that associated equipment is labelled to inform others not to switch the equipment on or reconnect patch leads
4. Remove connector dust cover and inspect for dust and damage using an optical microscope or video microscope
5. Clean connectors with recommended cleaning tools, using wet and dry methods as required and re-inspect
6. Replace connectors or patch cords when inspection reveals irreparable damage or contamination cannot be cleaned off
7. Place fibre patch leads in support pathway avoiding pressure, crushing and bending

Completed
Date:

Completed
Date:

Completed
Date:

Completed
Date:

Completed
Date:

Completed
Date:

Completed
Date:

Install indoor/outdoor cables and pigtails to an indoor enclosure

1. Undertake work in a controlled environment
2. Strip loose tube fibre cable and fit cable and fibres to an indoor enclosure
3. Prepare pigtails on workstation in an orderly manner matching cable fibre colour codes to pigtail colour codes as required

Completed
Date:

Completed
Date:

Completed
Date:

Terminate or fusion-splice cable

1. Prepare fibre for splicing, cleaning and cleaving
2. Splice prepared fibres
3. Shrink splice protective sleeve to spliced fibres and allow to cool

Completed
Date:

Completed
Date:

Completed
Date:

Terminate fibre using direct connectorisation

1. Prepare fibre (250 um and/or 900 um fibres) for mechanical splicing, cleaning and cleaving
2. Connect mechanical splice connector

Completed
Date:

Completed
Date:

Test circuit joints

1. Use visible light sources safely to determine continuity of patch cords and fusion/mechanical splices
2. Test each fibre circuit joint for transmission loss with a light source and power meter, and re-terminate joint or connector when transmission loss exceeds industry standards and manufacturer specifications
3. Record all measurements in dBm for customer handover

Completed
Date:

Completed
Date:

Completed
Date:

Remove fibre hazards from work area

1. Clean work area thoroughly to minimise risk of injury from glass fibre off-cuts
2. Dispose of waste safely according to relevant environmental requirements
3. Restore worksite to customer satisfaction

Completed
Date:

Completed
Date:

Completed
Date:

Document installation

1. Update plans and records with details of installation and test results
2. Notify customer of work completion and obtain sign-off

Completed
Date:

Completed
Date: