The important thing to remember when gathering evidence is that the more evidence the better - that is, the more evidence you gather to demonstrate your skills, the more confident an assessor can be that you have learned the skills not just at one point in time, but are continuing to apply and develop those skills (as opposed to just learning for the test!). Furthermore, one piece of evidence that you collect will not usualy demonstrate all the required criteria for a unit of competency, whereas multiple overlapping pieces of evidence will usually do the trick!
From the Wiki University
What evidence can you provide to prove your understanding of each of the following citeria?
Build and test DC and AC circuits
|
|
Identify any hazards and occupational health and safety (OHS) issues for a safe worksite and notify appropriate personnel Completed |
Evidence:
|
Connect a series and a parallel DC and AC circuit configuration following safe work practices Completed |
Evidence:
|
Choose the appropriate test equipment and measure the values of electrical quantities of the circuits Completed |
Evidence:
|
Use calculations to verify the measured values of the electrical quantities in a series and in a parallel circuit configuration Completed |
Evidence:
|
Compare the measured values to the calculated values and determine the reasons for any variations Completed |
Evidence:
|
Evaluate the results and determine the probable faults if relevant Completed |
Evidence:
|
Evaluate analog and digital signals
|
|
Compare the characteristics of an analog signal and a digital signal Completed |
Evidence:
|
Produce a layout using the building blocks to represent a typical analog and a digital circuit showing the different characteristics between of an analog signal and a digital signal Completed |
Evidence:
|
Produce 4-bit binary codes with their decimal equivalent to represent output voltages of a digital to analog converter Completed |
Evidence:
|
Choose the appropriate test equipment and measure the output voltage of a digital device for 'high' and 'low' logic states Completed |
Evidence:
|
Perform cable selection
|
|
Compare the basic transmission characteristics of different types of cables used in telecommunications and select the most appropriate cable type to suit the application characteristics Completed |
Evidence:
|
Connect two devices with a patch cable and test the connection Completed |
Evidence:
|
Test a wireless link
|
|
Select the types of wireless connections used in telecommunications Completed |
Evidence:
|
Set up a wireless link to connect two wireless devices following safe work practices Completed |
Evidence:
|
Transmit data over the link and verify the accuracy of the received data Completed |
Evidence:
|