The important thing to remember when gathering evidence is that the more evidence the better - that is, the more evidence you gather to demonstrate your skills, the more confident an assessor can be that you have learned the skills not just at one point in time, but are continuing to apply and develop those skills (as opposed to just learning for the test!). Furthermore, one piece of evidence that you collect will not usualy demonstrate all the required criteria for a unit of competency, whereas multiple overlapping pieces of evidence will usually do the trick!
From the Wiki University
What evidence can you provide to prove your understanding of each of the following citeria?
Identify the purpose of the jig or fixture
|
|
Purpose of the jig or fixture and the equipment it is to be used on is established Completed |
Evidence:
|
Proposed service life of jig or fixture is established Completed |
Evidence:
|
Tolerances allowed are identified Completed |
Evidence:
|
Materials for jig construction are established Completed |
Evidence:
|
Quality requirements for each stage of the construction process are identified Completed |
Evidence:
|
Plan jig or fixture construction
|
|
Plan of proposed jig or fixture is produced Completed |
Evidence:
|
Approval of design is gained through workplace procedures Completed |
Evidence:
|
Steps or stages in production are planned, noting check points for measurements and tests Completed |
Evidence:
|
Collect materials and equipment
|
|
Workplace health and safety requirements, including personal protection needs, are observed throughout the work Completed |
Evidence:
|
Sufficient materials to complete the project are assembled ready for use Completed |
Evidence:
|
Suitable work area is selected Completed |
Evidence:
|
Hand and/or power tools are identified and checked for serviceability and assembled in work area Completed |
Evidence:
|
Appropriate equipment required is identified and checked for serviceability Completed |
Evidence:
|
Construct the jig or fixture
|
|
Production plan is followed to construct the jig or fixture Completed |
Evidence:
|
Tools and equipment are used in accordance with workplace procedures Completed |
Evidence:
|
Quality checks are conducted at the identified points Completed |
Evidence:
|
Modifications are identified and recommended within workplace procedures Completed |
Evidence:
|
Modifications to the plan are documented and followed Completed |
Evidence:
|
Jig or fixture is checked for fitness for purpose Completed |
Evidence:
|
Clean up work area and maintain equipment
|
|
Any faulty and/or defective equipment is isolated and reported to appropriate persons Completed |
Evidence:
|
Material which can be reused is collected and stored Completed |
Evidence:
|
Waste and scrap are removed following workplace procedures Completed |
Evidence:
|
All tools, equipment and personal protective equipment are cleaned, maintained and appropriately stored Completed |
Evidence:
|
Work area is cleaned in accordance with workplace procedures Completed |
Evidence:
|