The important thing to remember when gathering evidence is that the more evidence the better - that is, the more evidence you gather to demonstrate your skills, the more confident an assessor can be that you have learned the skills not just at one point in time, but are continuing to apply and develop those skills (as opposed to just learning for the test!). Furthermore, one piece of evidence that you collect will not usualy demonstrate all the required criteria for a unit of competency, whereas multiple overlapping pieces of evidence will usually do the trick!
From the Wiki University
What evidence can you provide to prove your understanding of each of the following citeria?
Obtain job instructions
|
|
Job sheets or equivalent instructions are understood and correctly followed. Completed |
Evidence:
|
Mount work holding fixtures/devices/tools
|
|
Machine is prepared to accept work holding fixtures/devices/tools. Completed |
Evidence:
|
Preset tooling is mounted as required into machine/equipment. Completed |
Evidence:
|
Work holding fixtures/devices are set on machine as required using standard operating procedures. Completed |
Evidence:
|
Tool offset or datum settings are identified/verified against job sheet using standard operating procedures. Completed |
Evidence:
|
Program is loaded, selected and verified in accordance with job instructions. Completed |
Evidence:
|
Conduct pre-start checks
|
|
Pre-start checks are undertaken to standard operating procedures. Completed |
Evidence:
|
Correct safety procedures are observed and all safety equipment is checked for correct operation. Completed |
Evidence:
|
Set machine
|
|
Machine is set/adjusted to meet operational requirements and specifications. Completed |
Evidence:
|
Production samples are checked for compliance with specifications using standard operating procedures. Completed |
Evidence:
|
Instruct machine operator
|
|
Operator is instructed, if necessary, ensuring that all safety procedures and devices are in place. Completed |
Evidence:
|
Replace worn/damaged tooling
|
|
Where appropriate, preset tools are replaced, tool offsets are adjusted or other corrective action is taken using standard operating procedures. Completed |
Evidence:
|