The important thing to remember when gathering evidence is that the more evidence the better - that is, the more evidence you gather to demonstrate your skills, the more confident an assessor can be that you have learned the skills not just at one point in time, but are continuing to apply and develop those skills (as opposed to just learning for the test!). Furthermore, one piece of evidence that you collect will not usualy demonstrate all the required criteria for a unit of competency, whereas multiple overlapping pieces of evidence will usually do the trick!
From the Wiki University
What evidence can you provide to prove your understanding of each of the following citeria?
Observe safety precautions
|
|
Correct safety procedures are observed and protective clothing and safety glasses are worn. Completed |
Evidence:
|
Determine job requirements
|
|
Drawings are interpreted and sequence of operation is determined. Completed |
Evidence:
|
Tools are selected to produce components to specifications. Completed |
Evidence:
|
Disc size is determined according to relevant procedures. Completed |
Evidence:
|
Disc is cut to the correct size and tolerance. Completed |
Evidence:
|
Prepare form chucks for spinning
|
|
Metal turning lathe is set up for machining form chucks according to standard operating procedures and standards. Completed |
Evidence:
|
Form chuck is prepared for general spinning as per drawings and specifications. Completed |
Evidence:
|
Form chuck is prepared for seaming/swaging joints as per drawings and specifications. Completed |
Evidence:
|
Perform complex spinning operations
|
|
Spinning speeds are calculated for various metals and metal thicknesses using appropriate mathematical techniques and reference materials. Completed |
Evidence:
|
Correct back centre and form chucks are selected and mounted according to procedures and specifications. Completed |
Evidence:
|
Prepared disc is mounted for forming. Completed |
Evidence:
|
A full range of spinning accessories is used including: back centre, holding and sectional chucks, tee-rest, compound and additional slides, recessed and cranked followers, rollers and knurling wheels. Completed |
Evidence:
|
Spinning, beading, recessing, oval spinning, screw forming, (thread spinning) seaming, swaging, trimming finishing, annealing and pickling operations are performed to specification. Completed |
Evidence:
|
Check components for conformance to specifications
|
|
Components are checked for conformance to specifications using appropriate techniques, tools and equipment. Completed |
Evidence:
|
Remove and store components
|
|
Components are removed from the spinning lathe without marking or any deformation. Completed |
Evidence:
|
Components are correctly stored and packaged to avoid oxidation and damage. Completed |
Evidence:
|