The important thing to remember when gathering evidence is that the more evidence the better - that is, the more evidence you gather to demonstrate your skills, the more confident an assessor can be that you have learned the skills not just at one point in time, but are continuing to apply and develop those skills (as opposed to just learning for the test!). Furthermore, one piece of evidence that you collect will not usualy demonstrate all the required criteria for a unit of competency, whereas multiple overlapping pieces of evidence will usually do the trick!
From the Wiki University
What evidence can you provide to prove your understanding of each of the following citeria?
Determine job requirements
|
|
Follow standard operating procedures (SOPs) Completed |
Evidence:
|
Comply with work health and safety (WHS) requirements at all times |
|
Completed |
Evidence:
|
Use appropriate personal protective equipment (PPE) in accordance with SOPs |
|
Completed |
Evidence:
|
Identify job requirements from specifications, job sheets or work instructions |
|
Completed |
Evidence:
|
Select treatments and processes/ equipment for producing engineering finishes
|
|
Select appropriate treatment processes according to base metal type, the surface condition and relevant job specifications Completed |
Evidence:
|
Select operating/process parameters to achieve required coating |
|
Completed |
Evidence:
|
Select appropriate equipment, as required |
|
Completed |
Evidence:
|
Prepare work for engineering finishes
|
|
Mask (stop off) products for selective plating Completed |
Evidence:
|
Construct conforming anodes and fit, where applicable |
|
Completed |
Evidence:
|
Construct and fit shields and robbers, where applicable |
|
Completed |
Evidence:
|
Carry out pre-treatment processes, where necessary |
|
Completed |
Evidence:
|
Monitor and control operating conditions and processes for engineering coatings
|
|
Set operating/process parameters to produce required surface conditions/specifications Completed |
Evidence:
|
Monitor and confirm surface conditions of finished components and identify abnormalities |
|
Completed |
Evidence:
|
Take corrective actions to rectify non-conforming conditions |
|
Completed |
Evidence:
|
Maintain solutions for engineering finishes
|
|
Check solution compositions and confirm to specification/operating range Completed |
Evidence:
|
Determine adjustment requirements/additions |
|
Completed |
Evidence:
|
Make additions to adjust solution composition to correct operating range as necessary |
|
Completed |
Evidence:
|