The important thing to remember when gathering evidence is that the more evidence the better - that is, the more evidence you gather to demonstrate your skills, the more confident an assessor can be that you have learned the skills not just at one point in time, but are continuing to apply and develop those skills (as opposed to just learning for the test!). Furthermore, one piece of evidence that you collect will not usualy demonstrate all the required criteria for a unit of competency, whereas multiple overlapping pieces of evidence will usually do the trick!
From the Wiki University
What evidence can you provide to prove your understanding of each of the following citeria?
Identify scope of repair and/or fit required
|
|
Operational specifications for components are obtained from appropriate source and are interpreted and understood Completed |
Evidence:
|
Operation and condition of components are assessed against specifications Completed |
Evidence:
|
Faulty/worn components are identified Completed |
Evidence:
|
Causes of faults are determined using appropriate engineering principles, techniques, procedures, tools and equipment Completed |
Evidence:
|
Repair, replacement, adjustment or manufacture requirements are determined Completed |
Evidence:
|
Repair/replace faulty components
|
|
Where applicable, appropriate method of repair is determined Completed |
Evidence:
|
Where applicable, faulty components are repaired or adjusted to conform to specifications Completed |
Evidence:
|
Where applicable, replacement parts are selected from manufacturers' catalogues and assessed against specifications Completed |
Evidence:
|
Manufacture parts/components
|
|
Parts/component specifications are determined from appropriate source Completed |
Evidence:
|
Materials are selected to meet specification requirements Completed |
Evidence:
|
New components are produced in conformance to specifications using appropriate workshop practices Completed |
Evidence:
|
Completed components are inspected for compliance with dimensions Completed |
Evidence:
|
Where appropriate, component parts are marked for identification prior to assembly Completed |
Evidence:
|
Fit engineering components into assemblies or sub-assemblies
|
|
Fitting requirements and sequence of assembly are determined Completed |
Evidence:
|
Appropriate fitting principles and techniques are applied in the preparation and assembly of component parts using fastening equipment and methods which ensures conformance to specifications, operational performance, quality and safety Completed |
Evidence:
|
Using acceptable engineering practices, correct gland packing, jointing/gasket materials are selected and applied correctly in conformance to specifications and operational requirements Completed |
Evidence:
|
Correct lubrication requirements are determined by appropriate means and attended to where applicable Completed |
Evidence:
|
Final adjustments are performed on component assembly to meet operational specifications using acceptable engineering principles, fitting techniques and procedures Completed |
Evidence:
|
Check operation of repaired components/unit
|
|
Components/unit are checked under operational conditions for compliance to operational specifications using acceptable engineering principles to standard operating procedures Completed |
Evidence:
|
Out of specification modification/alterations are approved by appropriate authority and are recorded and documented to standard operating procedures Completed |
Evidence:
|
Final component assembly is commissioned and returned to service according to standard operating procedures Completed |
Evidence:
|