The important thing to remember when gathering evidence is that the more evidence the better - that is, the more evidence you gather to demonstrate your skills, the more confident an assessor can be that you have learned the skills not just at one point in time, but are continuing to apply and develop those skills (as opposed to just learning for the test!). Furthermore, one piece of evidence that you collect will not usualy demonstrate all the required criteria for a unit of competency, whereas multiple overlapping pieces of evidence will usually do the trick!
From the Wiki University
What evidence can you provide to prove your understanding of each of the following citeria?
Detail stairways, platforms, ladders and landings
|
|
Scheduling of detail drawings for stairways, platforms, ladders and landings are discussed with fabricator Completed |
Evidence:
|
Design information is checked and any requests for further information (RFIs) are made Completed |
Evidence:
|
Large scale set-out or 3D model of stairway is prepared and setting out points established Completed |
Evidence:
|
Stairway is dimensioned and detailed consistent with design information and the Building Code of Australia and AS 1657 Completed |
Evidence:
|
Holding down bolt layout and base plate details are prepared for ground floor supports or plinths Completed |
Evidence:
|
Detail other ancillary steel structures
|
|
Design information is received from client and fabrication schedule and requirements including allocation of components for shop and site fabrication confirmed Completed |
Evidence:
|
Size limitations of any sections requiring corrosion treatment or other surface finishing processes are determined Completed |
Evidence:
|
Transport limitations, erection procedures and limitations, and any relevant codes and regulations are determined Completed |
Evidence:
|
Rough large scale layout and 3D model is combined with trial assembly if required Completed |
Evidence:
|
Design information is used to directly insert or calculate and insert all dimensions, clearances, bolt layouts, weld types and dimensions, direction marks and surface finishes on shop drawings and erection diagrams Completed |
Evidence:
|
Detail drawings are sent for approval by designer Completed |
Evidence:
|