The important thing to remember when gathering evidence is that the more evidence the better - that is, the more evidence you gather to demonstrate your skills, the more confident an assessor can be that you have learned the skills not just at one point in time, but are continuing to apply and develop those skills (as opposed to just learning for the test!). Furthermore, one piece of evidence that you collect will not usualy demonstrate all the required criteria for a unit of competency, whereas multiple overlapping pieces of evidence will usually do the trick!
From the Wiki University
What evidence can you provide to prove your understanding of each of the following citeria?
Prepare to change dies
|
|
Determine when changeover will be required, and plan requirements for die change Completed |
Evidence:
|
Obtain dies and/or cores and all parts and tools to match the production order Completed |
Evidence:
|
Follow procedure for machine close-down and for informing relevant personnel Completed |
Evidence:
|
Take last-off samples as required for die reports Completed |
Evidence:
|
Close down machine in accordance with procedures Completed |
Evidence:
|
Prepare machine for changeover in accordance with procedures Completed |
Evidence:
|
Change dies
|
|
Plan removal process to ensure no damage to self, equipment or others Completed |
Evidence:
|
Remove, clean and store die according to workplace procedures applying corrosion protection if required Completed |
Evidence:
|
Attach replacement die ensuring that locating devices and marks are matched and securing devices are installed and tightened to specification Completed |
Evidence:
|
Set machine conditions for new die Completed |
Evidence:
|
Restart machine according to procedure Completed |
Evidence:
|
Dry cycle machine and die according to enterprise procedures Completed |
Evidence:
|
Check operation of die against product quality specifications Completed |
Evidence:
|
Check the first-off sample for compliance with required standards Completed |
Evidence:
|
Fine tune settings and other production variables as required Completed |
Evidence:
|
Note any equipment variances between actual production and documented set-up conditions Completed |
Evidence:
|
Complete workplace documentation and report to appropriate personnel Completed |
Evidence:
|
Anticipate die setting problems
|
|
Identify potential problems which may occur during the die changing and setting process Completed |
Evidence:
|
Determine possible causes of these problems Completed |
Evidence:
|
Identify most likely causes and prioritise appropriate actions Completed |
Evidence:
|
Rectify problems using appropriate solutions within area of responsibility Completed |
Evidence:
|
Recommend improvements in systems or procedures Completed |
Evidence:
|