The important thing to remember when gathering evidence is that the more evidence the better - that is, the more evidence you gather to demonstrate your skills, the more confident an assessor can be that you have learned the skills not just at one point in time, but are continuing to apply and develop those skills (as opposed to just learning for the test!). Furthermore, one piece of evidence that you collect will not usualy demonstrate all the required criteria for a unit of competency, whereas multiple overlapping pieces of evidence will usually do the trick!
From the Wiki University
What evidence can you provide to prove your understanding of each of the following citeria?
Design and make models
|
|
Establish model design from drawings, originals or in consultation with the customer Completed |
Evidence:
|
Select and prepare appropriate materials for model construction Completed |
Evidence:
|
Make models ensuring the final product is to specification, and shrinkage is allowed for Completed |
Evidence:
|
Set up and produce block moulds
|
|
Select appropriate model to meet specification Completed |
Evidence:
|
Determine required sections and parting lines Completed |
Evidence:
|
Check mould meets work health and safety (WHS) needs Completed |
Evidence:
|
Mix materials as required Completed |
Evidence:
|
Fill mould with mould material as required Completed |
Evidence:
|
Remove mould from model when required strength has been achieved Completed |
Evidence:
|
Finish mould to specifications and register correctly Completed |
Evidence:
|
Prepare cases and frames
|
|
Consult manufacturing schedule to determine type of mould to be made Completed |
Evidence:
|
Select appropriate frame or frames Completed |
Evidence:
|
Mix materials as required Completed |
Evidence:
|
Fill block mould Completed |
Evidence:
|
Remove block mould from the case and frame when required strength has been obtained Completed |
Evidence:
|
Register and date cases according to procedures Completed |
Evidence:
|
Prepare block mould for use Completed |
Evidence:
|
Prepare and make working moulds
|
|
Select the appropriate case/frame Completed |
Evidence:
|
Mix and pour mould material as required Completed |
Evidence:
|
Remove mould from model when required strength has been obtained Completed |
Evidence:
|
Finish and register moulds to procedures Completed |
Evidence:
|
Stack and dry moulds to procedures Completed |
Evidence:
|
Store moulds to procedures Completed |
Evidence:
|
Prepare dies
|
|
Consult manufacturing schedule to determine type of die to be made Completed |
Evidence:
|
Select and prepare required master die Completed |
Evidence:
|
Mix and pour die material as required Completed |
Evidence:
|
Remove die from master die when required strength has been obtained Completed |
Evidence:
|
Mark and finish dies to enterprise specifications Completed |
Evidence:
|
Cure and store dies to procedures Completed |
Evidence:
|
Respond to problems
|
|
Identify possible routine and non-routine problems in the equipment or process Completed |
Evidence:
|
Determine problems needing action Completed |
Evidence:
|
Determine possible fault causes Completed |
Evidence:
|
Rectify problem using appropriate solution within area of responsibility Completed |
Evidence:
|
Report problems outside area of responsibility to designated person Completed |
Evidence:
|