The important thing to remember when gathering evidence is that the more evidence the better - that is, the more evidence you gather to demonstrate your skills, the more confident an assessor can be that you have learned the skills not just at one point in time, but are continuing to apply and develop those skills (as opposed to just learning for the test!). Furthermore, one piece of evidence that you collect will not usualy demonstrate all the required criteria for a unit of competency, whereas multiple overlapping pieces of evidence will usually do the trick!
From the Wiki University
What evidence can you provide to prove your understanding of each of the following citeria?
Prepare to diagnose and rectify faults.
|
|
OHS procedures for a given work area are obtained and understood. Completed |
Evidence:
|
Established OHS risk control measures and procedures are followed in preparation for the work. Completed |
Evidence:
|
Safety hazards that have not previously been identified are documented and risk control measures devised and implemented in consultation with appropriate personnel. Completed |
Evidence:
|
The extent of faults is determined from reports and other documentation and from discussion with appropriate personnel. Completed |
Evidence:
|
Appropriate personnel are consulted to ensure the work is co-ordinated effectively with others involved on the work site. Completed |
Evidence:
|
Tools, equipment and testing devices needed to diagnose faults are obtained in accordance with established procedures and checked for correct operation and safety. Completed |
Evidence:
|
Diagnose and rectify faults.
|
|
OHS risk control measures and procedures for carrying out the work are followed. Completed |
Evidence:
|
The need to test or measure live is determined in strict accordance with OHS requirements and when necessary conducted within established safety procedures. Completed |
Evidence:
|
Circuits/machines/plant are checked as being isolated where necessary in strict accordance OHS requirements and procedures Completed |
Evidence:
|
Logical diagnostic methods are applied to diagnose telecommunication apparatus and systems em faults employing measurements and estimations of system operating parameters referenced to system operational requirements. Completed |
Evidence:
|
Suspected fault scenarios are tested as being the source of system problems. Completed |
Evidence:
|
Source of the fault is identified and appropriately competent persons are engaged to rectify the fault where it is outside the scope of electronics. Completed |
Evidence:
|
Faults in the electronic components of the system are rectified to raise telecommunication apparatus and system to its operation standard. Completed |
Evidence:
|
System is tested to verify that the system operates as intended and to specified requirements. Completed |
Evidence:
|
Decisions for dealing with unexpected situations are made from discussions with appropriate persons and job specifications and requirements. Completed |
Evidence:
|
Methods for dealing with unexpected situations are selected on the basis of safety and specified work outcomes. Completed |
Evidence:
|
Diagnosis and rectification activities are carried out efficiently without waste of materials or damage to apparatus and the surrounding environment or services and using sustainable energy practices. Completed |
Evidence:
|
Complete and report fault diagnosis and rectification activities.
|
|
OHS work completion risk control measures and procedures are followed. Completed |
Evidence:
|
Work site is made safe in accordance with established safety procedures. Completed |
Evidence:
|
Rectification of faults is documented in accordance with established procedures. Completed |
Evidence:
|
Appropriate person or persons notified, in accordance with established procedures, that the system faults have been rectified. Completed |
Evidence:
|