The important thing to remember when gathering evidence is that the more evidence the better - that is, the more evidence you gather to demonstrate your skills, the more confident an assessor can be that you have learned the skills not just at one point in time, but are continuing to apply and develop those skills (as opposed to just learning for the test!). Furthermore, one piece of evidence that you collect will not usualy demonstrate all the required criteria for a unit of competency, whereas multiple overlapping pieces of evidence will usually do the trick!
From the Wiki University
What evidence can you provide to prove your understanding of each of the following citeria?
Determine job requirements
|
|
Work requirements are determined from job sheet, instructions, drawings or visual inspection. Completed |
Evidence:
|
Required protective coating materials are identified according to job specification. Completed |
Evidence:
|
Required protective coating application equipment is identified according to job requirements. Completed |
Evidence:
|
Work site is prepared for application of protective coating. Completed |
Evidence:
|
Work piece prepared for application of protective coating
|
|
Surface condition is inspected for readiness for application of protective coating according to specification. Completed |
Evidence:
|
Unsuitable work pieces/surfaces and fabrication defects are identified and appropriate remedial action or reporting is undertaken in accordance with standard operating procedures. Completed |
Evidence:
|
Components are masked where protective coating application is not specified. Completed |
Evidence:
|
Conditions for overspray are identified. Completed |
Evidence:
|
Equipment prepared for application of surface coating materials
|
|
Required plant and equipment basic operations are understood. Completed |
Evidence:
|
Routine maintenance is undertaken on plant and equipment in accordance with standard operating procedures. Completed |
Evidence:
|
Status/reports are recorded by proforma or orally in accordance with standard operating procedures. Completed |
Evidence:
|
Conventional coating application equipment is assembled in accordance with equipment requirements and standard operating procedures. Completed |
Evidence:
|
Apply single pack coatings
|
|
Coating product type, solvent, uses, mixing procedure, clean-up and safety requirements are identified as appropriate. Completed |
Evidence:
|
Correct method of determining wet film thickness in accordance with specified dry film is demonstrated. Completed |
Evidence:
|
Coating material is thinned to suit the application method and to achieve required film thickness. Completed |
Evidence:
|
Coating is applied using specified application method and standard operating procedures. Completed |
Evidence:
|
Coating schedules can be outlined for metal and non-metal materials. Completed |
Evidence:
|
Coating application and curing technique are monitored according to standard operating procedures. Completed |
Evidence:
|
Clean and store equipment
|
|
Conventional coating application equipment is cleaned, disassembled and inspected for damage. Completed |
Evidence:
|
Faulty equipment is recorded and reported to appropriate personnel in accordance with standard operating procedures. Completed |
Evidence:
|
Coating application equipment is stored in accordance with standard operating procedures. Completed |
Evidence:
|
Inspect finish surface
|
|
Surface finish is assessed for profile size differences and uses. Completed |
Evidence:
|
Coating thickness is determined using appropriate instruments and results are compared with job specifications. Completed |
Evidence:
|
Total surface is inspected for conformance to specification in accordance with standard operating procedures. Completed |
Evidence:
|
Inspection results are recorded and reported in accordance with standard operating procedures. Completed |
Evidence:
|
Select and maintain personal protective equipment (PPE)
|
|
Appropriate personal protective equipment for coating application is selected according to job requirements and standard operating procedures. Completed |
Evidence:
|
Personal protective equipment is used appropriately in accordance with manufacturers' specifications and standard operating procedures. Completed |
Evidence:
|
Ancillary support attachments are identified and used. Completed |
Evidence:
|
Personal protective equipment is maintained in accordance with manufacturers' specification and standard operating procedures. Completed |
Evidence:
|